Molecular beam epitaxy was employed for the growth of HgCdTe-based n-p + -n device structures on (211)B oriented CdZnTe substrates. The device structures were processed as mesa isolated diodes, and operated as back-to-back diodes for the simultaneous detection of two closely spaced sub-bands in the mid-wave infrared spectrum. The devices were characterized by R 0 A values in excess of 5 × 10 5 Ω cm 2 at 78K, at f/2 fov and quantum efficiencies greater than 70% in each band. Infrared imagery from a focal plane array with 128 × 128 pixels was acquired simultaneously from each band at temperatures between 77 to 180K, with no observable degradation in the image quality with increase in temperature.
High-performance 20-mm unit-cell two-color detectors using an n-p 1 -n HgCdTe triple-layer heterojunction (TLHJ) device architecture grown by molecular beam epitaxy (MBE) on (211)-oriented CdZnTe substrates with midwavelength (MW) infrared and long wavelength (LW) infrared spectral bands have been demonstrated. Detectors with nominal MW and LW cut-off wavelengths of 5.5 mm and 10.5 mm, respectively, exhibit 78 K LW performance with .70 % quantum efficiency, reverse bias dark currents below 300 pA, and RA products (zero field of view, 150-mV bias) in excess of 1 3 10 3 Vcm 2 . Temperaturedependent current-voltage (I-V) detector measurements show diffusion-limited LW dark current performance extending to temperatures below 70 K with good operating bias stability (150 mV 6 50 mV). These results reflect the successful implementation of MBE-grown TLHJ detector designs and the introduction of advanced photolithography techniques with inductively coupled plasma (ICP) etching to achieve high aspect ratio mesa delineation of individual detector elements with benefits to detector performance. These detector improvements complement the development of high operability large format 640 3 480 and 1280 3 720 two-color HgCdTe infrared focal plane arrays (FPAs) to support third generation forward looking infrared (FLIR) systems.
Raytheon Vision Systems (RVS, Goleta, CA) in collaboration with HRL Laboratories (Malibu, CA) is contributing to the maturation and manufacturing readiness of third-generation, dual-color, HgCdTe infrared staring focal plane arrays (FPAs). This paper will highlight data from the routine growth and fabrication of 256 ϫ 256 30-µm unit-cell staring FPAs that provide dual-color detection in the mid-wavelength infrared (MWIR) and long wavelength infrared (LWIR) spectral regions. The FPAs configured for MWIR/MWIR, MWIR/LWIR, and LWIR/LWIR detection are used for target identification, signature recognition, and clutter rejection in a wide variety of space and ground-based applications. Optimized triple-layer heterojunction (TLHJ) device designs and molecular beam epitaxy (MBE) growth using in-situ controls has contributed to individual bands in all dual-color FPA configurations exhibiting high operability (>99%) and both performance and FPA functionality comparable to state-of-the-art, single-color technology. The measured spectral cross talk from out-of-band radiation for either band is also typically less than 10%. An FPA architecture based on a single-mesa, single-indium bump, and sequential-mode operation leverages current single-color processes in production while also providing compatibility with existing second-generation technologies.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.