This work discusses the temperature behavior of the various photoluminescence (PL) transitions observed in undoped, n- and p-doped GaN in the 9–300 K range. Samples grown using different techniques have been assessed. When possible, simple rate equations are used to describe the quenching of the transitions observed, in order to get a better insight on the mechanism involved. In undoped GaN, the temperature dependence of band edge excitonic lines is well described by assuming that the A exciton population is the leading term in the 50–300 K range. The activation energy for free exciton luminescence quenching is of the order of the A rydberg, suggesting that free hole release leads to nonradiative recombination. In slightly p-doped samples, the luminescence is dominated by acceptor related transitions, whose intensity is shown to be governed by free hole release. For high Mg doping, the luminescence at room temperature is dominated by blue PL in the 2.8–2.9 eV range, whose quenching activation energy is in the 60–80 meV range. We also discuss the temperature dependence of PL transitions near 3.4 eV, related to extended structural defects.

Kinetics 4.4.5. In depth optical assessment of MOVPE ELO GaN 4.4.6. New developments 4.4.7. Maskless ELO 4.5. Improvement of the standard ELO method 4.6. Pendeoepitaxy 4.6.1. Standard PE 4.6.2. Maskless PE 4.6.3. Further improvements 4.7. Two-step ELO (2S-ELO) 4.7.1. Experimental 4.7.2. In depth assessment of 2S-ELO 4.

III nitrides have become the most exciting challenge in optoelectronic materials in the last decade. Their intrinsic properties and an intense technological effort have made possible the fabrication of reliable and versatile detectors for short wavelengths. In this work, materials and devices issues are considered to provide a full picture of the advances in nitride UV photodetection. First, basic structures like photoconductors, Schottky, p-i-n and metal-semiconductor-metal photodiodes and phototransistors are compared, with emphasis on their specific properties and performance limitations. The efforts in the design and fabrication of more advanced detectors, in the search for higher quantum efficiency, contrast, signal-to-noise or speed operation, are reviewed afterwards. Metal-insulator-semiconductor diodes, avalanche photodetectors and GaN array detectors for UV imaging are also described. Further device optimization is linked with present materials issues, mainly due to the nitride quality, which is a direct result of the substrate used. The influence of substrates and dislocations on detector behaviour is discussed in detail. As an example of AlGaN photodetector applications, monitoring of the solar UV-B radiation to prevent erythema and skin cancer is presented.

The strain in GaN epitaxial layers grown on silicon (111) substrates by metalorganic vapor phase epitaxy has been investigated. The insertion of AlN/GaN superlattices was found to decrease the stress sufficiently for avoiding crack formation in an overgrown thick (2.5 μm) GaN layer. X-ray diffraction and photoluminescence measurements are used to determine the effect of these AlN/GaN superlattices on the strain in the subsequent GaN layers. A reduction of threading dislocation density is also observed by transmission electron microscopy and atomic force microscopy when such superlattices are used. Strong band edge photoluminescence of GaN on Si(111) was observed with a full width at half maximum of the bound exciton line as low as 6 meV at 10 K. The 500 arcsec linewidth on the (002) x-ray rocking curve also attests the high crystalline quality of GaN on Si (111), when using these AlN/GaN superlattices.