This article states a condition monitoring strategy for wind turbines using a statistical data-driven modeling approach by means of supervisory control and data acquisition (SCADA) data. Initially, a baseline data-based model is obtained from the healthy wind turbine by means of multiway principal component analysis (MPCA). Then, when the wind turbine is monitorized, new data is acquired and projected into the baseline MPCA model space. The acquired SCADA data are treated as a random process given the random nature of the turbulent wind. The objective is to decide if the multivariate distribution that is obtained from the wind turbine to be analyzed (healthy or not) is related to the baseline one. To achieve this goal, a test for the equality of population means is performed. Finally, the results of the test can determine that the hypothesis is rejected (and the wind turbine is faulty) or that there is no evidence to suggest that the two means are different, so the wind turbine can be considered as healthy. The methodology is evaluated on a wind turbine fault detection benchmark that uses a 5 MW high-fidelity wind turbine model and a set of eight realistic fault scenarios. It is noteworthy that the results, for the presented methodology, show that for a wide range of significance, α ∈ [1%, 13%], the percentage of correct decisions is kept at 100%; thus it is a promising tool for real-time wind turbine condition monitoring.

In this paper a new topology of four degrees-of-freedom 3T1R fully-parallel manipulator is presented, which is defined only using lower kinematic pairs. The paper starts with a complete type synthesis of different topologies of fully-parallel manipulators that can perform the so-called Schönflies motion, based on the Theory of Groups of Displacements. After imposing some practical requirements, the different possibilities of manipulators are reduced to only one topology of fully-parallel and fully-symmetrical parallel manipulator. Then, the kinematic analysis of the manipulator is shown, including the closed-form resolution of both forward and inverse position problems, the velocity and the singularity analysis. Finally, a prototype of the manipulator is presented, which is intended to be used in pick and place applications.

No abstract

No abstract

No abstract

No abstract

The multiobjective optimization of a four-degree-of-freedom symmetric parallel manipulator for Schönflies-motion generation is the subject of this paper. First, the inverse positioning problem is discussed, along with its velocity analysis. The workspace is then analyzed, thereby deriving a closed-form expression of the workspace volume, which depends on the orientation of the moving platform. Next, the isotropic design of the manipulator is obtained. Then, the dexterity analysis of the manipulator is conducted, which is one objective of the optimum design of the manipulator, a second objective being a normalized workspace volume. Finally, the results of the optimization process are reported in terms of a set of Pareto-optimum pairs of the design parameters.

No abstract