Presently, rice cultivars are categorized according to amylose content into three groups: low, medium and high amylose content cultivars. The correlation of amylose content with gelatinization properties, retrogradation, and pasting properties of eleven cultivars of Thai rice were investigated. Rice flour was prepared from milled rice by the wet grinding process. Onset (To), peak (Tp) and conclusion (Tc) temperatures of gelatinization, (determined by DSC) were found to be highly positively correlated with amylose levels. This correlation could be used for prediction of amylose content of rice flour. Low amylose starch could also be characterized by low degree of retrogradation (%R). The data obtained from RVA‐viscograms (peak viscosity, breakdown, setback, and pasting temperature) can be used only for characterization of the group of low amylose starches (waxy rice). It was demonstrated that low amylose rice starch provided the highest peak viscosity and breakdown and the lowest setback and pasting temperature among the groups investigated.

Rice bran oil (RBO) is used in foods, cosmetics, and pharmaceuticals due to its desirable health, flavor, and functional attributes. We investigated the effects of biopolymer emulsifier type and environmental stresses on the stability of RBO emulsions. Oil-in-water emulsions (5% RBO, 10 mM citrate buffer) stabilized by whey protein isolate (WPI), gum arabic (GA), or modified starch (MS) were prepared using high-pressure homogenization. The new MS used had a higher number of octenyl succinic anhydride (OSA) groups per starch molecule than conventional MS. The droplet diameters produced by WPI and MS were considerably smaller (d < 300 nm) than those produced by GA (d > 1000 nm). The influence of pH (3 to 8), ionic strength (0 to 500 mM NaCl), and thermal treatment (30 to 90 °C) on the physical stability of the emulsions was examined. Extensive droplet aggregation occurred in WPI-stabilized emulsions around their isoelectric point (4 < pH < 6), at high salt (> 200 mM, pH 7), and at high temperatures (>70 °C, pH 7, 150 mM NaCl), which was attributed to changes in electrostatic and hydrophobic interactions between droplets. There was little effect of pH, ionic strength, and temperature on emulsions stabilized by GA or MS, which was attributed to strong steric stabilization. In summary: WPI produced small droplets at low concentrations, but they had poor stability to environmental stress; GA produced large droplets and needed high concentrations, but they had good stability to stress; new MS produced small droplets at low concentrations, with good stability to stress. Practical Application: This study showed that stable rice bran oil-in-water emulsions can be formed using biopolymer emulsifiers. These emulsions could be used to incorporate RBO into a wide range of food products. We compared the relative performance of whey protein, GA, and a new MS at forming and stabilizing the emulsions. The new OSA MS was capable of forming small stable droplets at relatively low concentrations.

Thai jasmine rice, KDML 105, is known as the best quality rice. It is known not only for its aroma but also for its good cooking and eating qualities. Amylose content (AC), gel consistency (GC) and gelatinization temperature (GT) are important traits determining rice quality. A population of recombinant inbred lines (RIL) derived from KDML105 x CT9993 cross was used to study the genetic control of AC, GC and GT traits. A total of 191 markers were used in the linkage map construction. The 1605.3 cM linkage map covering nearly the whole rice genome was used for QTL (define QTL) analysis. Four QTLs for AC were detected on chromosomes 3, 4, 6 and 7. These QTLs accounted for 80% of phenotypic variation explained (PVE) in AC. The presence of one major gene as well as several modifiers was responsible for the expression of the trait. Two QTLs on chromosome 6 and one on chromosome 7 were detected for GC, which accounts for 57% of PVE. A single gene of major effect along with modifier genes controls GC from this cross. The QTLs in the vicinity of waxy locus were major contributors in the expression of AC and GC. The finding that the position of QTLs for AC and GC were near each other may reflect tight linkage or pleiotropy. Three QTLs were detected, one on chromosome 2 and two on chromosome 6, which accounted for 67% of PVE in GT. Just like AC and GC, one major gene and modifier genes governed the variation in GT resulting from the KDML105 x CT9993 cross. Breeding for cooking and eating qualities will largely rely on the preferences of the end users.

Chicken eggshell powder has been proposed as an attractive source of calcium for human health to increase bone mineral density in an elderly population with osteoporosis. However, factors affecting calcium transport of eggshell calcium have not yet been evaluated. Chicken eggshell contains about 1.0% (w/w) matrix proteins in addition to a major form of calcium carbonate (95%, w/w). In this study, we found that soluble eggshell matrix proteins remarkably enhance calcium transport using in vitro Caco-2 cell monolayers grown on a permeable support. The total calcium transport across Caco-2 monolayers showed an increase of 64% in the presence of 100 microg/well soluble eggshell matrix proteins. The active enhancer with a molecular mass of 21 kDa was isolated by reversed phase high-performance liquid chromatography and did not correspond to any previously identified protein. The N-terminal sequence was determined to be Met-Ala-Val-Pro-Gln-Thr-Met-Val-Gln. The possible mechanisms of eggshell matrix protein-mediated increase in calcium transport and the potential significance of eggshell calcium as a nutraceutical are discussed.

No abstract

No abstract

The objective of this study was to investigate the effect of soy protein isolate on functional properties and consumer acceptance of gluten-free rice spaghetti (GFRS) made from rice flour. Dry-milled high-amylose (Chai Nat 1) rice flour was premixed with dry-milled waxy (RD 6) rice flour at a ratio of 90:10 (w/w) with the soy protein isolate (SPI) concentration varying between 0, 2.5, 5.0, 7.5, 10.0 %, db. The GFRS formulation was processed using a co-rotating twin-screw extruder up to 95 °C with a screw speed of 220 rpm, 32 % moisture content, and then dried at 40 C. The GFRS samples were analyzed by differential scanning calorimetry (DSC), X-ray diffraction, scanning electron microscopy (SEM) and texture parameters. Increasing SPI decreased the starch retrogradation of GFRS, whereas the enthalpy change of the amylose-lipid complex increased and crystallinity decreased. SEM revealed that the surface of GFRS containing SPI was much more porous than that of GFRS without SPI. The cooked GFRS containing 5.0 % SPI showed the best eating quality with increased firmness and tensile strength, and decrease stickiness. The GFRS samples were evaluated on the bases of cooking qualities and sensory evaluation. The results showed that the GFRS containing 5.0 % SPI decrease the cooking time from 17.6 to 13.7 min and cooking loss from 25.4 to 17.0 %. Overall acceptability of cooked GFRS containing 5.0 % SPI was the highest among all GFRS samples.

No abstract