No abstract

No abstract

No abstract

The Zonguldak terrane is a Gondwana-derived continental microplate along the Black Sea coast in northwest Anatolia. It includes a Cadomian basement, with oceanic- and island-arc sequences, unconformably overlain by siliciclastic rocks of Ordovician to Middle Silurian age. After a period of deformation and erosion, late Lower Devonian (Emsian) quartzites and shallow-marine limestones unconformably cover Middle Silurian (Wenlock) graptolitic shales. Along several cross sections across the unconformity plane, the mineralogical characteristics of the Paleozoic sedimentary rocks in the Zonguldak terrane are studied to check whether this regional unconformity is only of epeirogenic nature or the result of a thermal event. In addition to the appearance of kaolinite in Devonian units, crystal-chemical data of illites show a sudden jump at the unconformity plane. The b cell dimension values of illites of Ordovician–Silurian units are somewhat higher than those of Devonian–Carboniferous units and show a drastic drop between the Silurian and Devonian units. The new mineralogic data indicate that the pre-Emsian rocks in the Zonguldak terrane experienced a thermodynamo event, prior to the Emsian transgression. This Caledonian-time event is also reported in east Moesian terrane but not noticed in the neighboring Istanbul–Zonguldak and in the west Moesian – Balkan – Kreishte terranes. By this, it is suggested that Zonguldak and east Moesian terranes behaved independently from the Istanbul–Balkan terranes during the closure of the Rheic Ocean. They very likely docked to Laurussia during Emsian by strike-slip faults and remained thereon at its platform margin, where the Middle–Late Devonian shallow-platform conditions were followed by fluvial (lagoon and delta) conditions and deposition of coal during Late Carboniferous.

No abstract

No abstract

The Antalya Unit, one of the allochthonous units of the Tauride belt, is of critical, regional tectonic importance because of the presence of rifting remnants related to the break-up of the northern margin of Gondwana during Triassic time. Paleozoic — Mesozoic sedimentary rocks of the Antalya Unit consist mainly of calcite, dolomite, quartz, feldspar, and phyllosilicate (illite-smectite, smectite, kaolinite, chlorite, illite, chlorite-smectite, and chlorite-vermiculite) minerals. Illite-smectite (I-S) was found in all of the sequences from Cambrian to Cretaceous, but smectite was only identified in Late Triassic-Cretaceous sediments. R0 I-S occurs exclusively in early-diagenetic Triassic—Cretaceous units of the Alakırçay Nappe (rift sediments), whereas R3 I-S is present in late-diagenetic to low-anchimetamorphic Cambrian—Early Triassic units of the Tahtalıdağ Nappe (pre-rift sediments). Kübler Index (KI) values and the illite content of I-S reflect increasing diagenetic grades along with increasing depth. Major-element, trace-element, rare-earth-element (REE), and stable-isotope (O and H) compositions were investigated in dioctahedral and trioctahedral smectites and I-S samples from the pre-rift and rift-related formations. Both total layer charge and interlayer K increase, whereas tetrahedral Si and interlayer Ca decrease from smectite to R3 I-S. Trace-element and REE concentrations of the I-S are greater in pre-rift sediments than in rift sediments, except for P, Eu, Ni, Cu, Zn, and Bi. On the basis of North American Shale Composite (NASC)-normalized values, the REE patterns of I-S in the pre-rift and rift sediments are clearly separate and distinct. Oxygen (δ18O) and hydrogen (δD) values relative to SMOW (Standard Mean Oceanic Water) of smectite and I-S reflect supergene conditions, with decreasing δ18O but increasing δD values with increasing diagenetic grade. Lower dD values for these I-S samples are characteristic of rift sediments, and pre-rift sediments have greater values. On the basis of isotopic data from these I-S samples, the diagenesis of the Antalya Unit possibly occurred under a high geothermal gradient (>35ºC/km), perhaps originating under typical extensional-basin conditions with high heat flow. The geochemical findings from I-S and smectites were controlled by diagenetic grade and can be used as an additional tool for understanding the basin maturity along with mineralogical data.

A 2 m thick brecciated zone containing magnesian minerals is present at the contact of tectonites and cumulates. Tectonites below this zone comprise serpentinized orthopyroxenite and serpentinite. An alteration zone with vein-type bedding comprises four different levels; from bottom to top they are: (1) green-brown serpentinite with dolomite (0.9 m), (2) light greenish-white dolomite with serpentine (0.5 m), (3) white dolomite with sepiolite (0.4 m), and (4) greenish-white dolomite with smectite-chlorite (0.2 m). The first level has a mineral association of serpentine + dolomite ± calcite ± aragonite, the second level consists of dolomite + serpentine ± calcite or dolomite + magnesite + serpentine, the third level comprises dolomite + sepiolite, and the fourth level is made up of dolomite + chlorite + smectite + serpentine. Dolomite, the main mineral of the alteration zone, occurs as coarse crystals (microsparitic-sparitic) in fractures and as small crystals (microsparitic-micritic) in the matrix, which includes serpentine and gabbro relics. Sepiolite developed at the edges and surfaces of dolomite and as fibrous forms in voids. Cumulate rocks above this zone comprise uralitic gabbros. The occurrences of magnesian minerals developed in three stages: the first stage was the serpentinization of olivine; the second stage was the dissolution of serpentine by groundwater and/or meteoric water containing carbon dioxide; and the last stage was the synthesis of neoformed minerals.