No abstract

The kinetics of formation of a mixture of two polymers [poly(methyl methacrylate) and polyurethane] in situ in the course of two simultaneously proceeding reactions was studied in the presence of various amount of a filler (fumed silica). It was shown that the filler affects the rates of both reactions. In addition, the filler exerts an influence on the phase separation induced by the chemical reaction increasing the amount of a filler increases the time for the onset of phase separation. The effects observed may be explained both by the increase in the viscosity of the reaction system due to introduction of a filler and by selective adsorption of reaction system components at the interface with filler particles. In all cases, phase separation in the early stages of reaction proceeds in a four‐component system (two polymers formed and two initial compounds) and obeys the spinodal mechanism. It is also shown that the final morphology is determined far from the end of the reaction and before establishing the equilibrium state. © 2003 Society of Chemical Industry

No abstract

No abstract

No abstract

No abstract

No abstract

In this work, based on the results of dynamic mechanical studies, the damping efficiency of two-layer polyurethane (PU) composites designed by gluing two films of synthesized PU with different glass transition temperatures (Tg) was estimated. The damping efficiency was estimated by the parameters of the mechanical losses (tanδ) peak. To vary Tg, three types of PU with different chemical nature and structure were synthesized. The effect of an increase in the difference between the Tg of the initial PU (ΔTg) on the damping efficiency of the two-layer PU composites formed from them is analyzed. The effective damping temperature range (ΔT) was estimated as the temperature range under conditions tanδ ≥ 0,3 and tanδ ≥ 0,6. It was shown that at ΔТg = 7 °С a two-layer PU composite has one relaxation maximum, and its temperature range of damping efficiency expands in comparison with ΔТ for individual PU. Under the conditions ΔТg = 23 °С and ΔТg = 30 °С, two-layer PU composites exhibit damping efficiency in two temperature regions at tanδ ≥ 0,3, which provides an additional temperature range of effective damping. The essential role of the PU structure of each of the layers in the formation of a two-layer composite by gluing has been determined. Easier penetration of residues of the adhesive organic solvent into the surface of the PU film with a linear structure leads to plasticization of the corresponding layer in the composite and reduces Tg. It is shown that a two-layer structure can be used to solve specific problems related to the adjustment or broadening the effective damping temperature range.