Understanding the suppression of ferroelectricity in perovskite thin films is a fundamental issue that has remained unresolved for decades. We report a synchrotron x-ray study of lead titanate as a function of temperature and film thickness for films as thin as a single unit cell. At room temperature, the ferroelectric phase is stable for thicknesses down to 3 unit cells (1.2 nanometers). Our results imply that no thickness limit is imposed on practical devices by an intrinsic ferroelectric size effect.

We report the observation of periodic 180 degrees stripe domains below the ferroelectric transition in thin films. Epitaxial PbTiO3 films of thickness d=1.6 to 42 nm on SrTiO3 substrates were studied using x-ray scattering. Upon cooling below T(C), satellites appeared around Bragg peaks indicating the presence of 180 degrees stripe domains of period Lambda=3.7 to 24 nm. The dependence of Lambda on d agrees well with theory including epitaxial strain effects, while the suppression of T(C) for thinner films is significantly larger than that expected solely from stripe domains.

Dynamics of domain interfaces in a broad range of functional thin-film materials is an area of great current interest. In ferroelectric thin films, a significantly enhanced piezoelectric response should be observed if non-180 degrees domain walls were to switch under electric field excitation. However, in continuous thin films they are clamped by the substrate, and therefore their contribution to the piezoelectric response is limited. In this paper we show that when the ferroelectric layer is patterned into discrete islands using a focused ion beam, the clamping effect is significantly reduced, thereby facilitating the movement of ferroelastic walls. Piezo-response scanning force microscopy images of such islands in PbZr0.2Ti0.8O3 thin films clearly point out that the 90 degrees domain walls can move. Capacitors 1 microm2 show a doubling of the remanent polarization at voltages higher than approximately 15 V, associated with 90 degrees domain switching, coupled with a d33 piezoelectric coefficient of approximately 250 pm V-1 at remanence, which is approximately three times the predicted value of 87 pm V-1 for a single domain single crystal.

Scanning force microscopy (SFM) is becoming a powerful technique with great potential both for imaging and for control of domain structures in ferroelectric materials at the nanometer scale. Application of SFM to visualization of domain structures in ferroelectric thin films is described. Imaging methods of ferroelectric domains are based on the detection of surface charges in the noncontact mode of SFM and on the measurement of the piezoelectric response of a ferroelectric film to an external field applied by the tip in the SFM contact mode. This latter mode can be used for nondestructive evaluation of local ferroelectric and piezoelectric 101 102 GRUVERMAN, AUCIELLO & TOKUMOTO properties and for manipulation of domains of less than 50 nm in diameter. The effect of the film thickness and crystallinity on the imaging resolution is discussed. Scanning force microscopy is shown to be a technique well suited for nanoscale investigation of switching processes and electrical degradation effects in ferroelectric thin films.