SABRE catalysts [Ir(H)2(η2-pyruvate)(sulfoxide)(NCH) transfer magnetisation from para-hydrogen to pyruvate yielding hyperpolarised 13C NMR signals enhanced by >2000-fold. Properties of the catalyst control efficiency.

The conversion of [IrCl(COD)(IMes)] (COD = cis,cis-1,5-cyclooctadiene, IMes = 1,3-bis(2,4,6-trimethyl-phenyl)imidazole-2-ylidene) in the presence of an excess of para-hydrogen (p-H2) and a substrate (4-aminopyridine (4-AP) or 4-methylpyridine (4-MP)) into [Ir(H)2(IMes)(substrate)3]Cl is monitored by 1H NMR spectroscopy using a benchtop (1 T) spectrometer in conjunction with the p-H2-based hyperpolarization technique signal amplification by reversible exchange (SABRE). A series of single-shot 1H NMR measurements are used to monitor the chemical changes that take place in solution through the lifetime of the hyperpolarized response. Non-hyperpolarized high-field 1H NMR control measurements were also undertaken to confirm that the observed time-dependent changes relate directly to the underlying chemical evolution. The formation of [Ir(H)2(IMes)(substrate)3]Cl is further linked to the hydrogen isotope exchange (HIE) reaction, which leads to the incorporation of deuterium into the ortho positions of 4-AP, where the source of deuterium is the solvent, methanol-d4. Comparable reaction monitoring results are achieved at both high-field (9.4 T) and low-field (1 T). It is notable that the low sensitivity of the benchtop (1 T) NMR enables the use of protio solvents, which when used here allows the effects of catalyst formation and substrate deuteration to be separated. Collectively, these methods illustrate how low-cost low-field NMR measurements provide unique insight into a complex catalytic process through a combination of hyperpolarization and relaxation data.

Benchtop NMR spectrometers operating with magnetic fields of 1–2 T at sub-ppm resolution coupled with SABRE hyperpolarization show great promise as analytical platforms that can be used outside the traditional laboratory environment.

Early warning systems detect new psychoactive substances (NPS), while dedicated monitoring programs and routine drug and toxicology testing identify fluctuations in prevalence. We report the increasing prevalence of the synthetic cannabinoid recep-. ADB-BUTINACA was first detected in a seizure in Sweden in 2019, and we report its detection in 13 routine Swedish forensic toxicology cases soon after. In January 2021, ADB-BUTINACA was detected in SCRA-infused papers seized in Scottish prisons and has rapidly increased in prevalence, being detected in 60.4% of the SCRA-infused papers tested between January and July 2021. In this work, ADB-BUTINACA was incubated with human hepatocytes Robert Kronstrand, Craig McKenzie, and Henrik Green contributed equally to the study.

Raman spectroscopy has been used to provide a rapid, non-invasive and non-destructive quantification method for determining the parahydrogen fraction of hydrogen gas. The basis of the method is the measurement of the ratio of the first two rotational bands of hydrogen at 355 cm −1 and 586 cm −1 corresponding to parahydrogen and orthohydrogen, respectively. The method has been used to determine the parahydrogen content during a production process and a reaction. In the first example, the performance of an in-house liquid nitrogen cooled parahydrogen generator was monitored both at-line and on-line. The Raman measurements showed that it took several hours for the generator to reach steady state and hence, for maximum parahydrogen production (50 %) to be reached. The results obtained using Raman spectroscopy were compared to those obtained by at-line low-field NMR spectroscopy. While the results were in good agreement, Raman analysis has several advantages over NMR for this application. The Raman method does not require a reference sample, as both spin isomers (ortho and para) of hydrogen can be directly detected, which simplifies the procedure and eliminates some sources of error. In the second example, the method was used to monitor the fast conversion of parahydrogen to orthohydrogen in-situ. Here the ability to acquire Raman spectra every 30 s enabled a conversion process with a rate constant of 27.4 × 10 −4 s −1 to be monitored. The Raman method described here represents an improvement on previously reported work, in that it can be easily applied on-line and is approximately 500 times faster. This offers the potential of an industrially compatible method for determining parahydrogen content in applications that require the storage and usage of hydrogen.

No abstract

No abstract

No abstract