Kraft lignin (KL) is a renewable source of many valuable intermediate biochemical products currently derived from petroleum. An excessive of lignin comes from pulping wastewater caused an adverse pollution problems hence affecting human and aquatic life. A comprehensive study pertaining to emulsion liquid membrane (ELM) extraction of lignin from pulping wastewater was presented. ELM formulation contains Aliquat 336 as carrier, kerosene as diluent, sodium bicarbonate (NaHCO3 ) as stripping agent and Span 80 as surfactant. The emulsion stability was investigated at different surfactant concentrations, homogenizer speed and emulsification time. Modifier (2-ethyl-1-hexanol) was added to avoid segregation of third phase while improving the emulsion stability. At optimum conditions, 95% and 56% of lignin were extracted and recovered, respectively at 10 min of extraction time, 0.007 M of Aliquat 336, 0.1 M of NaHCO3 and 1:5 of treat ratio. Additional of modifier was contributed to highest recovery up to 98%. The ELM process was found to be equally feasible and quite effective in the recovery of KL from real pulping wastewater. Therefore, ELM process provides a promising alternative technology to recover KL from pulping wastewater while solving the environmental problems simultaneously.

No abstract

Lignosulfonate is a major byproduct from the sulphite pulping process which is the most abundant biopolymer and largely unused. Although lignosulfonate is nontoxic, it impacts brownish black colour to water and makes the water unsuitable for reuse. However, lignosulfonate have a wide range application, such as production of vanillin, animal feed pellets binder and pesticides. Therefore, an efficient separation technique of lignosulfonate from the wastewater is necessary in order to meet the wastewater treatment requirement and as a source of valuable material for industrial applications. In this study, lignosulfonate was extracted from aqueous solution through flat sheet supported liquid membrane (SLM) using trioctylamine (TOA) as carrier. SLM has great potential for the separation lignosulfonate as it offers advantages such as simultaneous extraction and stripping steps, low consumption of carrier and high selectivity. The important parameters governing the extraction process are the types of support material, types of solvents, types of stripping agent, feed phase flow rate and pH were investigated. The favorable condition for extraction was obtained by using TOA-Kerosene-PVDF membrane system, 0.5M NaOH as stripping agent, 100 mL/min of flow rate and feed at pH 2 with 37.5% of lignosulfonate removal. The result demonstrated that the membrane support remains stable for more than 9 hours, hence demonstrating promising separation technique for lignosulfonate.

Effluent containing colour/dyes, especially reactive dyes, becomes a great concern of wastewater treatment because it is toxic to human life and aquatic life. In this study, reactive dye of Black B was separated using the supported liquid membrane process. Commercial polypropylene membrane was used as a support of the kerosene-tridodecylamine liquid membrane. Several parameters were tested and the result showed that almost 100% of 70 ppm Black B was removed and 99% of 70 ppm Black B was recovered at pH 2 of the feed phase containing 0.00001 M Na2SiO3, flow rate of 150 ml/min and 0.2 M NaOH. The membrane support also remained stable for up to 36 hours under an optimum condition.