No abstract

In this paper the results of research about the influences of the incident angle, the measurement distance and object colour and reflectivity on the number of acquired points while using a lasertriangulation scanner on CNC-machines, are presented. The number of points is an essential parameter of a successful 3D surface reconstruction, although it is rarely considered as a subject of research. In this research we identified the scanning parameters to acquire a sufficient number of points for any surface reconstruction. The causes of the results are also identified and could be considered when creating automatic-measurement strategies for CNC-machines. Finally, the equation for an estimation of the number of acquired points in the optimal area of measuring parameters for the case example is also introduced.

No abstract

No abstract

No abstract

Nowadays, a large number of different tools that support early phases of design are available to engineers. In the past decade a specialized set of CAD-based tools were developed, that support the ideation process by generating different design alternatives according to the criteria given by the designer. Two types of tools are discussed in this paper: topology optimization and generative design tools. To investigate to what extent these tools are suitable for use in early design phases and what are the main differences between them, a study was conducted on an industrial case.

No abstract

Injection moulding is currently the most widely employed production method for polymer gears. Current standardised gear metrology methods, which are based on metal gear inspection procedures, do not provide the key information regarding the geometric stability of injection moulded gears and are insufficient for a thorough gear inspection. The study developed novel areal quality parameters, along with a so-called moulding runout quality parameter, with a focus on the injection moulding method. The developed parameters were validated on twenty-nine gear samples, produced in the same moulding tool using various processing parameters. The gears were measured using a high-precision structured-light 3D scanner. The influence of injection moulding process parameters on the introduced novel quality parameters was investigated. The developed moulding runout quality parameter proved to be effective in evaluating the shrinkage that can occur in the injection moulding process. The novel moulding runout parameter returned an average value of −21.8 μm in comparison to 29.4 μm exhibited by the standard parameter on all the gears, where the negative value points directly to mould shrinkages. The rate of cooling was determined to be the most influential factor for the shrinkage of the gear. The developed areal parameters demonstrated to be advantageous in characterising the deviations on the teeth more comprehensively.