Numerical and experimental investigations were conducted in a transonic centrifugal compressor stage composed of a backswept splittered unshrouded impeller and a vaned diffuser. The characteristic curves of the compressor stage resulting from the unsteady simulations and the experiments show a good agreement over the whole operating range. On the contrary, the total pressure ratio resulting from the steady simulations is clearly overestimated. A detailed analysis of the flow field at design operating point led to identify the physical mechanisms involved in the blade row interaction that underlie the observed shift in performance. Attention was focused on the deformation in shape of the vane bow shock wave due its interaction with the jet and wake flow structure emerging from the impeller. An analytical model is proposed to quantify the time-averaged effects of the associated entropy increase. The model is based on the calculation of the losses across a shock wave at various inlet Mach numbers corresponding to the moving of the jet and wake flow in front of the shock wave. The model was applied to the compressor stage performance calculated with the steady simulations. The resulting curve of the overall pressure ratio as a function of the mass flow is clearly shifted towards the unsteady results. The model in particular enhances the prediction of the choked mass flow.
This paper presents the unsteady data acquisition system used to measure the pressure field in high speed compressors. Details and electronic sketches are given for the conditioners developed in-house that have been used to amplify and to filter the pressure signal with the aim of acquiring data up to 150 kHz. A discussion of the experimental results carried out in a centrifugal compressor is proposed. Through different processing of the pressure signals and a comparison with URANS simulations, the excitation of the pressure transducers by the pressure waves generated by shock waves that occur between the impeller and the diffuser is highlighted. The levels of pressure fluctuations measured when entering into surge are also presented and reveal very repetitive behaviour of the flow instabilities.
The study is focused on the analysis of the flow structure within the vaned diffuser of a transonic high-pressure centrifugal compressor stage. The analyzed time-dependent flow field comes from unsteady computations of the stage using a 3D Navier-Stokes code with a phase-lagged technique, at an operating point close to the design point. A good comparison with available experimental data allowed the use of CFD for investigating the details of the flow in order to assess the effect of the unsteadiness in the diffuser flow development. Applying various data processing techniques, it is shown that the unsteadiness is due to the jet and wake flow structure emerging from the radial impeller and to the pressure waves brought about by the interaction between the vane bow shock wave and the impeller blade. The interaction between the pressure waves and the vane pressure side boundary layer leads to a pulsating behavior of separated bubbles within the diffuser. The pressure waves are similar in shape and strength whatever the blade height. The observed change in the flow field from hub to tip is due to migration of the low momentum fluid contained in the wake toward the pressure side/hub corner.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.
hi@scite.ai
10624 S. Eastern Ave., Ste. A-614
Henderson, NV 89052, USA
Copyright © 2024 scite LLC. All rights reserved.
Made with 💙 for researchers
Part of the Research Solutions Family.