As a promising candidate for expanding the capacity of drug loading in silica nanoplatforms, hollow mesoporous silica nanoparticles (HMSNs) are gaining increasing attention. In this study, porous nanosilica (PNS) and HMSNs were prepared by the sol-gel method and template assisted method, then further used for Rhodamine (RhB) loading. To characterize the as-synthesized nanocarriers, a number of techniques, including X-ray diffraction (XRD), transmission electron microscopy (TEM), nitrogen absorption-desorption isotherms, dynamic light scattering (DLS), thermogravimetric analysis (TGA), and Fourier transform infrared spectroscopy (FTIR) were employed. The size of HMSN nanoparticles in aqueous solution averaged 134.0 ± 0.3 nm, which could be adjusted by minor changes during synthesis, whereas that of PNS nanoparticles was 63.4 ± 0.6 nm. In addition, the encapsulation of RhB into HMSN nanoparticles to form RhB-loaded nanocarriers (RhB/HMSN) was successful, achieving high loading efficiency (51.67% ± 0.11%). This was significantly higher than that of RhB-loaded PNS (RhB/PNS) (12.24% ± 0.24%). Similarly, RhB/HMSN also possessed a higher RhB loading content (10.44% ± 0.02%) compared to RhB/PNS (2.90% ± 0.05%). From those results, it is suggested that prepared HMSN nanocarriers may act as high-capacity carriers in drug delivery applications.

In this work, AgNPs/PVA/Cellulose was used as a substrate material for surface Raman scattering enhancement. Silver nanoparticles (AgNPs) was synthesized by Lee and Meisel's method with the average particles size of 15.4 nm. Then, this silver colloid was made a homogenous coating on polyvinyl alcohol and cellulose film and structural characteristics of this material were determined using Scanning Electron Microscopy (SEM). The findings demonstrated that the Raman shifts of the pesticide will be identified by the SERS method at 1660 cm −1 , 2234 cm −1 (strong intensity), and at 3077 cm −1 , 1033 cm −1 , 1457 cm −1 (medium intensity) when using the excited laser with wavelength of 532 nm. Under excited laser, the limit of chlorfenapyr detection is 1 ppm (mg l −1 ), allowing determination of chlorfenapyr residue in food. Potential applications identified food samples containing chlorfenapyr residue for rapid detection, low cost, non-destructive nature and minimal sample preparation.