This paper reports the numerical determination of the entropy generation due to heat transfer, mass transfer and fluid friction in steady state for laminar double diffusive convection, in an inclined enclosure with heat and mass diffusive walls, by solving numerically the mass, momentum, species conservation and energy balance equations, using a Control Volume FiniteElement Method. The influences of the inclination angle, the thermal Grashof number and the buoyancy ratio on total entropy generation were investigated. The irreversibilities localization due to heat transfer, mass transfer and fluid friction is discussed for three inclination angles at a fixed thermal Grashof number.

Abstract:The influence of an external oriented magnetic field on entropy generation in natural convection for air and liquid gallium is numerically studied in steady-unsteady states by solving the mass, the momentum and the energy conservation equations. Entropy generation depends on five parameters which are: the Prandtl number, the irreversibility coefficients, the inclination angle of the magnetic field, the thermal Grashof and the Hartmann numbers. Effects of these parameters on total and local irreversibilities as well as on heat transfer and fluid flow are studied. It was found that the magnetic field tends to decrease the convection currents, the heat transfer and entropy generation inside the enclosure. Influence of inclination angle of the magnetic field on local irreversibility is then studied.

Natural convection in an inclined rectangular cavity filled with air is numerically investigated. The cavity is heated and cooled along the active walls whereas the two other walls of the cavity are adiabatic. Entropy generation due to heat transfer and fluid friction has been determined in transient state for laminar natural convection by solving numerically: the continuity, momentum and energy equations, using a Control Volume Finite Element Method. The structure of the studied flows depends on four dimensionless parameters which are: the thermal Grashof number, the inclination angle, the irreversibility distribution ratio and the aspect ratio of the cavity. The obtained results show that entropy generation tends towards asymptotic values for lower thermal Grashof number values, whereas it takes an oscillative behavior for higher values of thermal Grashof number. Transient entropy generation increases towards a maximum value, then decreases asymptotically to a constant value that depends on aspect ratio of the enclosure. Entropy generation increases with the increase of thermal Grashof number, irreversibility distribution ratio and aspect ratio of the cavity. Bejan number is used to measure the predominance of either thermal or viscous irreversibility. At local level, irreversibility charts show that entropy generation is mainly localized on bottom corner of the left heated wall and upper corner of the right cooled wall.

No abstract

Thermosolutal convection in a square cavity filled with air and submitted to an inclined magnetic field is investigated numerically. The cavity is heated and cooled along the active walls with a mass gradient whereas the two other walls of the cavity are adiabatic and insulated. Entropy generation due to heat and mass transfer, fluid friction and magnetic effect has been determined in transient state for laminar flow by solving numerically the continuity, momentum energy and mass balance equations, using a Control Volume Finite-Element Method. The structure of the studied flows depends on four dimensionless parameters which are the Grashof number, the buoyancy ratio, the Hartman number and the inclination angle. The results show that the magnetic field parameter has a retarding effect on the flow in the cavity and this lead to a decrease of entropy generation, Temperature and concentration decrease with increasing value of the magnetic field parameter.

No abstract

No abstract

The pre-incubation of digestate and recycling of microbes inside a continuously stirred tank reactor (CSTR) are effective ways to optimize the anaerobic digestion process and improve the performance of biogas and methane production, also in existing biogas plants. In this study, a digestate incubation system using a nutrient mix to boost the activity of microbes was coupled to a CSTR to boost biogas and methane production. This system has been tested both on a lab scale and on an industrial scale. On a pilot scale, the system achieved an increase of +16.47 v% in biogas production with respect to the conventional anaerobic digestion process, and an increase of +2 v% in methane content (from 65.94 v% to 67.84 v%). On an industrial scale, the use of this incubation reactor with a capacity of 1 m3 has led to an increase in methane yield of 12 v%. This system allows to maintain the syntrophic relationship between acid-producing bacteria and methanogens and contemporary push the development of methanogens. Moreover, it is an economic system to be integrated into an existing biogas plant given the small volume and the simplicity of the incubation reactor.