Polymers in space may be subjected to a barrage of incident atoms, photons, and/or ions. Atomic layer deposition (ALD) techniques can produce films that mitigate many of the current challenges for space polymers. We have studied the efficacy of various ALD coatings to protect Kapton polyimide, FEP Teflon, and poly(methyl methacrylate) films from atomic-oxygen and vacuum ultraviolet (VUV) attack. Atomic-oxygen and VUV studies were conducted with the use of a laser-detonation source for hyperthermal O atoms and a D2 lamp as a source of VUV light. These studies used a quartz crystal microbalance (QCM) to monitor mass loss in situ, as well as surface profilometry and scanning electron microscopy to study the surface recession and morphology changes ex situ. Al2O3 ALD coatings protected the underlying substrates from atomic-oxygen attack, and the addition of TiO2 coatings protected the substrates from VUV-induced damage. The results indicate that ALD coatings can simultaneously protect polymers from oxygen-atom erosion and VUV radiation damage.
A combination of beam-surface-scattering, quartz-crystal-microbalance, and surface-recession experiments was conducted to study the effects of various combinations of O atoms [in the O((3)P) ground state], Ar atoms, and vacuum ultraviolet (VUV) light on fluorinated ethylene-propylene copolymer (FEP) Teflon and poly(methyl methacrylate) (PMMA). A laser-breakdown source was used to create hyperthermal beams containing O and O(2) or Ar. A D(2) lamp provided a source of VUV light. O atoms with 4 eV of translational energy or less did not react with a pristine FEP Teflon surface. Volatile O-containing reaction products were observed when the O-atom energy was higher than 4.5 eV, and the signal increased with the O-atom energy. Significant erosion of FEP Teflon ( approximately 20% of Kapton H) was observed when it was exposed to the hyperthermal O/O(2) beam with an average O-atom energy of 5.4 eV. FEP Teflon and PMMA that were exposed to VUV light alone exhibited much less mass loss. Collision-induced dissociation by hyperthermal Ar atoms also caused mass loss, similar in magnitude to that caused by VUV light. There were no observed synergistic effects when VUV light or Ar bombardment was combined with O/O(2) exposure. For both FEP Teflon and PMMA, the erosion yields caused by simultaneous exposure to O/O(2) and either VUV light or Ar atoms could be approximately predicted by adding the erosion yield caused by O/O(2), acting individually, to the erosion yield caused by the individual action of either VUV light or Ar atoms.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.