Kapton polyimde is extensively used in solar arrays, spacecraft thermal blankets, and space inflatable structures. Upon exposure to atomic oxygen in low Earth orbit (LEO), Kapton is severely eroded. An effective approach to prevent this erosion is to incorporate polyhedral oligomeric silsesquioxane (POSS) into the polyimide matrix by copolymerizing POSS monomers with the polyimide precursor. The copolymerization of POSS provides Si and O in the polymer matrix on the nano level. During exposure of POSS polyimide to atomic oxygen, organic material is degraded, and a silica passivation layer is formed. This silica layer protects the underlying polymer from further degradation. Laboratory and space-flight experiments have shown that POSS polyimides are highly resistant to atomic-oxygen attack, with erosion yields that may be as little as 1% those of Kapton. The results of all the studies indicate that POSS polyimide would be a space-survivable replacement for Kapton on spacecraft that operate in the LEO environment.

This paper presents a combined experimental and theoretical study of the dynamics of O((3)P) + D(2) collisions, with emphasis on a center-of-mass (c.m.) collision energy of 25 kcal mol(-1). The experiments were conducted with a crossed-molecular-beams apparatus, employing a laser detonation source to produce hyperthermal atomic oxygen and mass spectrometric detection to measure the product angular and time-of-flight distributions. The novel beam source, which enabled these experiments to be conducted, contributed unique challenges to the experiments and to the analysis, so the experimental methods and approach to the analysis are discussed in detail. Three different levels of theory were used: (1) quasiclassical trajectories (QCT), (2) time-independent quantum scattering calculations based on high-quality potential surfaces for the two lower-energy triplet states, and (3) trajectory-surface-hopping (TSH) studies that couple the triplet surfaces with the lowest singlet surface using a spin-orbit Hamiltonian derived from ab-initio calculations. The latter calculations explore the importance of intersystem crossing in the dynamics. Both experiment and theory show that inelastically scattered O atoms scatter almost exclusively in the forward direction, with little or no loss of translational energy. For the reaction, O((3)P) + D(2) --> OD + D, the experiment shows that, on average, approximately 50% of the available energy goes into product translation and that the OD product angular distributions are largely backward-peaked. These results may be interpreted in light of the QCT and TSH calculations, leading to the conclusion that the reaction occurs mainly on triplet potential energy surfaces with, at most, minor intersystem crossing to a singlet surface. Reaction on either of the two low-lying reactive triplet surfaces proceeds through a rebound mechanism in which the angular distributions are backward-peaked and the product OD is both vibrationally and rotationally excited. The quantum scattering results are in good agreement with QCT calculations, indicating that quantum effects are relatively small for this reaction at a collision energy of 25 kcal mol(-1).

Hybrid inorganic/organic polymers have been prepared by copolymerizing a polyimide having the same chemical repeat unit as Kapton with an open-cage polyhedral oligomeric silsesquioxane (POSS). These POSS/polyimide hybrid polymers are Kapton-like polymers containing POSS nanoparticles that are chemically bound into the polymer chain. Samples of these POSS polyimides, as well as polyimide controls, have been exposed to a hyperthermal 0-atom beam that is produced by a laser-detonation source. Exposed and unexposed surfaces have been characterized by surface profilometry, atomic force microscopy, and X-ray photoelectron spectroscopy The data indicate that the POSS-containing polyimides have significantly lower erosion yields than Kapton, because they form a surface SiO2 layer which passivates the surface and protects the underlying polymer from further 0-atom attack. These results suggest promise for the use of a POSS polyimide polymer as a "drop-in" replacement for Kapton on spacecraft operating in the low-Earth orbital environment.

The excitation function for the reaction, O(3P)+CH4-->H+OCH3, has been measured in a crossed molecular beams experiment and determined with direct dynamics calculations that use the quasiclassical trajectory method in conjunction with a recently developed semiempirical Hamiltonian. Good agreement is found between experiment and theory, enabling us to address two fundamental issues for the O(3P)+CH4 reaction that arise for all O(3P)+saturated hydrocarbon reactions: (1) the importance of triplet excited states that correlate adiabatically to ground-state reactants and products and (2) the importance of intersystem crossing processes involving the lowest singlet surface [corresponding to reaction with O(1D)]. Our results indicate that the first excited triplet surface contributes substantially to the cross section when the collision energy exceeds the reaction barrier (approximately 2 eV) by more than 0.5 eV. Although triplet-singlet crossings may occur at all energies, we have found that their effect on the excitation function is negligible for the collision energies studied-up to 1.5 eV above threshold.

No abstract