Biofuels include energy-enriched chemicals produced directly through biological processes or derived from the chemical conversion of the biomass of previously living organisms. Biofuels can be classified into two categories: primary and secondary biofuels. The main biofuels are produced directly from burning woody plant material or cellulose and dry animal dung. Secondary biofuels can be classified into three generations, and each is produced indirectly from plant and animal materials. The first-generation biofuel is ethanol derived from starch-rich food crops or biodiesel, extracted from animal fat wastes such as cooking oil. The second generation is bioethanol derived from non-food cellulosic biomass and biodiesel derived from oil-rich plant seeds such as soybean or jatropha. The third generation is a biofuel produced from cyanobacteria, microalgae, and other microbes, which is the most promising approach to meet global energy demand. This community service aims to explain innovation and provide knowledge to technology players, namely technicians, operators, supervisors, and workshop supervisors, about the use of alternative fuels of sesame oil for small-capacity automatic gasoline engines. The counseling results show that the performance and exhaust gas results are optimal so that the technology actors know the quality and quantity of the alternative energy.
The optimal approach to enhance solar panel efficiency and decrease the degradation rate is to lower the temperature range of the surface area. It will be applied by allowing the panels/modules to be cooled and lessening the heat stored in the solar cells through an operation. In the research using experimental methods, the solar panels used have a capacity of 100 WP as a source of micro-power generation, the angle of inclination of the panels is adjusted with variations of 150, 200, and 250. The cooling system uses water, the process of draining water using a submersible pump mounted on a reservoir Water flows to all surfaces of the solar panel and circulates continuously when operating. The experimental outcomes show that the cooling process utilizing water has reduced the temperature operating of the solar panels. The decrease in average temperature occurred in all variations of 23%. The cooling process significantly affects the output power and operational efficiency; circulating cooling can increase the scale of incidents solar radiation on the solar panel due to the refractive effect of the water layer and keep the surface of the solar panel clean from dirt and dust. Output power and operational efficiency have increased in almost all variations in the angle of the solar panel tilt (150, 200, and 250), output power has increased by an average of 22%, and efficiency has increased by on average of 2%
Penelitian ini dilakukan untuk memberikan penjelasan tentang studi eksperimental pengaruh variasi beban dan variasi aliran terhadap efek water hammer. Dimana efek ini akan mempengaruhi tekanan air yang akan dihasilkan jika setelah pembebanan dan perubahan bukaan valve yang diberikan akan menghasilkan efek water hammer yang lebih baik atau cenderung lebih buruk bila tidak memiliki kedua efek tersebut. Penelitian ini dilakukan dengan melakukan studi eksperimental yang bertujuan untuk mengetahui tekanan yang terjadi pada saat air mengalir dan kemudian ditutup secara tiba-tiba oleh katup pembuangan yang dihubungkan dengan aliran pipa dengan diameter 1,5 inci setelah beban dan variasi bukaan katup. Pada uji efek water hammer dengan sistem pompa water hammer hidrolik ini dimungkinkan untuk mengubah bukaan katup pemasukan air dengan perubahan beban katup yang diberikan untuk menentukan tekanan water hammer maksimum 378334,64 Pa setelah menerima katup bukaan 80 derajat dan tambahan beban 250 gr, dan efek water hammer terkecil dengan nilai 321376,44 Pa pada bukaan katup 50 derajat dan beban 150 gr. Saat menginvestigasi pompa hydraulic ram ini, dapat disimpulkan bahwa ukuran bukaan valve atau jumlah air yang masuk dan besarnya beban pada discharge valve yang akan mempengaruhi tekanan akan meningkat.
Penyakit Gerd (Gastroesophageal Reflux Disease) adalah penyakit kronis pada sistem pencernaan. Penyakit ini sangat terkait dengan gaya hidup dan mudah kambuh saat penderitanya sedang stres. Gerd terjadi ketika asam lambung naik kembali ke esofagus atau kerongkongan. Akibatnya, kerongkongan mengalami iritasi. Oleh sebab itu kami bekerjasama dengan UKM Jelita bermaksud untuk memberikan wawasan pencegahan penyakit Gerd kepada pelaku UKM Jelita. UKM Jelita adalah perkumpulan UKM yang dijalankan oleh para lansia jelang lima puluh tahun di daerah Manukan Rejo Surabaya. Seperti diketahui pada saat pandemi Covid-19 berlangsung banyak usaha dari UKM Jelita mengalami penurunan meskipun tidak drastis dan mengakibatkan penyakit gerd karena mereka mengalami stress. Selain stres dengan adanya pandemi mereka juga stres dengan menurunnya omzet penjualannya. Kami selaku tim pengabdi bermaksud membantu pencegahan gerd ini dengan mengedukasi tentang stress management. Metode pelaksanaan yaitu dengan melakukan sosialisasi penyakit Gerd dan cara mengatasinya. Dengan adanya kegiatan ini diharapkan pelaku UKM Jelita bisa melakukan tindakan preventif terhadap penyakit Gerd.
Sebagian besar pengusaha Lontong masih menggunakan kayu bakar dan alat seadanya dalam proses produksinya. Sehingga kapasitas produksi dan kualitasnya relatif masih rendah. Guna mengatasi permasalahan tersebut, Tim Program Pemberdayaan Masyarakat (PPM) Fakultas Teknik Universitas Wijaya Putra merancang Teknologi Tepat Guna (TTG SS 316 L) untuk memproduksi Lontong dengan hasil yang lebih banyak serta kualitas yang lebih baik. Teknologi TTG SS 316 L ini mampu meningkatkan produksi 3 kali dari proses sebelumnya. Waktu perebusan dapat dipercepat dari 6 jam menjadi 2 jam dengan hasil produksi 200 buah/hari meningkat menjadi 800 buah/hari. TTG SS 316 L ini berbahan food grade yang dilengkapi dengan temperature gauge dan pressure gauge serta menggunakan bahan bakar LPG sehingga lebih aman dan efisien. Lontong yang dihasilkan bisa matang dengan sempurna dan mempunyai kualitas yang lebih baik. Pelatihan dan pendampingan dilakukan pada mitra UKM agar penerapan TTG sesuai dengan yang diharapkan.Kata Kunci: UKM Lontong, Produktivitas, TTG
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.
hi@scite.ai
10624 S. Eastern Ave., Ste. A-614
Henderson, NV 89052, USA
Copyright © 2024 scite LLC. All rights reserved.
Made with 💙 for researchers
Part of the Research Solutions Family.