Abstract

We describe the fabrication of optimized plasmonic substrates in the form of immobilized nanorod assemblies (INRA) for surface-enhanced Raman spectroscopy (SERS). Included are high-resolution scanning electron micrograph (SEM) images of the surface structures, along with a mechanistic description of their growth. It is shown that, by varying the size of support microspheres, the surface plasmon resonance is tuned between 330 and 1840 nm. Notably, there are predicted optimal microsphere sizes for each of the commonly used SERS laser wavelengths of 532, 633, 785, and 1064 nm.

Normal and surface-enhanced Raman spectra for a set of substituted benzenethiols were measured experimentally and calculated from static polarizability derivatives determined with time-dependent density functional theory (TDDFT). Both silver and gold cluster−thiolate complexes were studied to investigate how the chemical enhancement varies with substituent. The experimental relative peak intensities and positions are well-matched by their theoretical counterparts. The static chemical enhancement of the ring stretching modes near 1600 cm −1 is determined experimentally and computationally for each derivative, and it is found that the experimental enhancement varies by a factor of 10 as a result of chemical substitution, with stronger electron donating groups on the benzene unit leading to higher enhancements. The calculated trends with substitution match experiment well, suggesting that TDDFT is describing the chemical effect qualitatively, if not quantitatively, in the static (low-frequency) limit. A two-state model is developed, providing qualitative insight into the results in terms of the variation of ligand-to-metal charge-transfer excitation energy with substitution.

The potential for discriminating between analytes by their unique vibrational signature makes surface-enhanced Raman scattering (SERS) extremely interesting for chemical detection. However, for molecules that weakly adsorb to non-functionalized plasmonic materials, detection by SERS remains a key challenge. Here we present an approach to SERS-based detection where a polycrystalline metal-organic framework (MOF) film is used to recruit a range of structurally similar volatile organic compounds for detection by SERS. MOF films were grown on the surface of Ag "films-over-nanospheres" (FONs), which have previously been shown to enhance Raman signals of surface adsorbates by a factor of 10(7). Upon exposing the MOF-coated FON to benzene, toluene, nitrobenzene, or 2,6-di-tert-butylpyridine, the MOF film traps the vapors at the FON surface, allowing the unique Raman spectrum of each vapor to be recorded. By contrast, these analytes do not adsorb to a bare FON surface and thus cannot be detected by conventional SERS substrates. Pyridine was also tested as a Ag-adsorbing control analyte. Concentration dependence and time resolved measurements provide evidence for the hypothesis that the vapors are reversibly adsorbed on the surfaces of MOF nanocrystals exposed at grain boundaries. This represents a generalized approach for confining aromatic molecules through interactions with the MOF surface, which can be applied for future SERS-based sensors.

This work demonstrates the development of near-infrared surface-enhanced Raman spectroscopy (NIR-SERS) for the identification of eosin Y, an important historical dye. NIR-SERS benefits from the absence of some common sources of SERS signal loss including photobleaching and plasmonic heating, as well as an advantageous reduction in fluorescence, which is beneficial for art applications. This work also represents the first rigorous comparison of the enhancement factors and the relative merits of two plasmonic substrates utilized in art applications; namely, citrate-reduced silver colloids and metal film over nanosphere (FON) substrates. Experimental spectra are correlated in detail with theoretical absorption and Raman spectra calculated using time-dependent density functional theory (TDDFT) in order to elucidate molecular structural information and avoid relying on pigment spectral libraries for dye identification.

This paper demonstrates the direct sensing of glucose at physiologically relevant concentrations with surface-enhanced Raman spectroscopy (SERS) on gold film-over-nanosphere (AuFON) substrates functionalized with bisboronic acid receptors. The combination of selectivity in the bisboronic acid receptor and spectral resolution in the SERS data allow the sensors to resolve glucose in high backgrounds of fructose and, in combination with multivariate statistical analysis, detect glucose accurately in the 1-10 mM range. Computational modeling supports assignments of the normal modes and vibrational frequencies for the monoboronic acid base of our bisboronic acids, glucose and fructose. These results are promising for the use of bisboronic acids as receptors in SERS-based in vivo glucose monitoring sensors.

For many Surface-Enhanced Raman Spectroscopy (SERS) applications, the enhancing substrate must exhibit a number of critical properties that include low cost, robustness, and reproducibly high enhancement over large areas of the substrate. In this study we investigate the SERS fundamental enhancement factor of silver Immobilized Nanorod Assembly (AgINRA) substrates as a function of both the dielectric sphere diameter (310–780 nm) and the input laser wavelength (633–1064 nm) with a technique called plasmon-sampled surface-enhanced Raman excitation spectroscopy (PS-SERES). The nonresonant molecule benzenethiol was chosen as the probe molecule. Higher enhancement factors (EFs) were measured as the plasmon resonance and excitation wavelength’s relative separation were optimized and both moved toward the infrared region, ultimately eclipsing the 108 mark. This is the highest EF to date measured on this type of large-area substrate. The enhancement factors reported here are the result of efficient coupling between free space photons and the surface plasmon states in the metal INRA substrate. Coupled with their robustness and ease of fabrication, these results further underscore the value and versatility of metal INRA substrates in the field of surface-enhanced Raman spectroscopy.

Simplicity and low cost has positioned inkjet paper- and fabric-based 3D substrates as two of the most commonly used surface-enhanced Raman spectroscopy (SERS) platforms for the detection and the identification of chemical and biological analytes down to the nanogram and femtogram levels. The relationship between far-field and near-field properties of these 3D SERS platforms remains poorly understood and warrants more detailed characterization. Here, we investigate the extremely weak optical scattering observed from commercial and home-fabricated paper-, as well as fabric-based 3D SERS substrates. Using wavelength scanned surface-enhanced Raman excitation spectroscopy (WS-SERES) and finite-difference time-domain (FDTD) calculations we were able to determine their near-field SERS properties and correlate them with morphological and far-field properties. It was found that nanoparticle dimers, trimers, and higher order nanoparticle clusters primarily determine the near-field properties of these substrates. At the same time, the far-field response of 3D SERS substrates either originates primarily from the monomers or cannot be clearly defined. Using FDTD we demonstrate that LSPR bands of nanoparticle aggregates near perfectly overlap with the maxima of the near-field surface-enhanced Raman scattering responses of the 3D SERS substrates. This behaviour of far-field spectroscopic properties and near-field surface-enhanced Raman scattering has not been previously observed for 2D SERS substrates, known as nanorod arrays. The combination of these analytical approaches provides a full spectroscopic characterization of 3D SERS substrates, while FDTD simulation can be used to design new 3D SERS substrates with tailored spectral characteristics.