Influences from solvents on charge storage in titanium carbide MXenes. (2019) Nature Energy, 4 (3). 241-248.

MXenes are a recently discovered class of 2D materials with an excellent potential for energy storage applications. Because MXene surfaces are hydrophilic and attractive interaction forces between the layers are relatively weak, water molecules can spontaneously intercalate at ambient humidity and significantly influence the key properties of this 2D material. Using complementary X-ray and neutron scattering techniques, we demonstrate that intercalation with potassium cations significantly improves structural homogeneity and water stability in MXenes. In agreement with molecular dynamics simulations, intercalated potassium ions reduce the water self-diffusion coefficient by 2 orders of magnitude, suggesting greater stability of hydrated MXene against changing environmental conditions.

Understanding of structural, electrical, and gravimetric peculiarities of water vapor interaction with ion-intercalated MXenes led to design of a multimodal humidity sensor. Neutron scattering coupled to molecular dynamics and ab initio calculations showed that a small amount of hydration results in a significant increase in the spacing between MXene layers in the presence of K and Mg intercalants between the layers. Films of K- and Mg-intercalated MXenes exhibited relative humidity (RH) detection thresholds of ∼0.8% RH and showed monotonic RH response in the 0-85% RH range. We found that MXene gravimetric response to water is 10 times faster than their electrical response, suggesting that HO-induced swelling/contraction of channels between MXene sheets results in trapping of HO molecules that act as charge-depleting dopants. The results demonstrate the use of MXenes as humidity sensors and infer potential impact of water on structural and electrical performance of MXene-based devices.

There is widespread interest in determining the structural features of redox-active electrochemical energy storage materials that enable simultaneous high power and high energy density. Here, we present the discovery that confined interlayer water in crystalline tungsten oxide hydrates, WO3·nH2O, enables highly reversible proton intercalation at subsecond time scales. By comparing the structural transformation kinetics and confined water dynamics of the hydrates with anhydrous WO3, we determine that the rapid electrochemical proton intercalation is due to the ability of the confined water layers to isolate structural transformations to two dimensions while stabilizing the structure along the third dimension. As a result, these water layers provide both structural flexibility and stability to accommodate intercalation-driven bonding changes. This provides an alternative explanation for the fast energy storage kinetics of materials that incorporate structural water and provides a new strategy for enabling high power and high energy density with redox-active layered materials containing confined fluids.

We explore the influence of the solvent dipole moment on cation-anion interactions and transport in 1-butyl-3-methyl-imidazolium bis(trifluoromethylsulfonyl), [BMIM][Tf2N]. Free energy profiles derived from atomistic molecular dynamics (MD) simulations show a correlation of the cation-anion separation and the equilibrium depth of the potential of mean force with the dipole moment of the solvent. Correlations of the ion diffusivity with the dipole moment and the concentration of the solvent were further demonstrated by classical MD simulations. Quasi-elastic neutron scattering experiments with deuterated solvents reveal a complex picture of nanophase separation into the ionic liquid-rich and solvent-rich phases. The experiment corroborates the trend of concentration- and dipole moment-dependent enhancement of ion mobility by the solvent, as suggested by the simulations. Despite the considerable structural complexity of ionic liquid-solvent mixtures, we can rationalize and generalize the trends governing ionic transport in these complex electrolytes.

Most polar solvent molecules are unstable toward electrode materials used in Li-based batteries. Solid electrolytes and ionic liquids are far more stable; however, they have relatively low conductivity, and therefore electrical energy storage devices based on them would suffer from low power. Solvent-in-salt (SIS) systems combine chemical stability with relatively high conductivity. Here, we show how the nature of the employed anion affects the structure and dynamics of SIS systems. The transport of ions in lithium bis(fluorosulfonyl)imide (Li-FSI) systems was determined to be always faster than that in lithium bis(trifluoromethanesulfonyl)imide (Li-TFSI) systems. Moreover, we found that viscosity does not solely control conductivity and that the lower conductivity of TFSI − solutions is related to their stronger interaction with the solvent. This restricts solvent dynamics and slows down ion motions compared to that of FSI − . Interestingly, the TFSI−solvent interaction also leads to better charge separation (weaker ion−ion correlations) and a higher transference number for Li. Our results suggest that the ability to tune the solvent network formed around the anions may further improve electrolyte conductivity and Li transference number for safer and more efficient energy storage devices.

MXenes exhibit excellent capacitance at high scan rates in sulfuric acid aqueous electrolytes, but the narrow potential window of aqueous electrolytes limits the energy density. Organic electrolytes and room‐temperature ionic liquids (RTILs) can provide higher potential windows, leading to higher energy density. The large cation size of RTIL hinders its intercalation in‐between the layers of MXene limiting the specific capacitance in comparison to aqueous electrolytes. In this work, different chain lengths alkylammonium (AA) cations are intercalated into Ti3C2Tx, producing variation of MXene interlayer spacings (d‐spacing). AA‐cation‐intercalated Ti3C2Tx (AA‐Ti3C2), exhibits higher specific capacitances, and cycling stabilities than pristine Ti3C2Tx in 1 m 1‐ethly‐3‐methylimidazolium bis‐(trifluoromethylsulfonyl)‐imide (EMIMTFSI) in acetonitrile and neat EMIMTFSI RTIL electrolytes. Pre‐intercalated MXene with an interlayer spacing of ≈2.2 nm, can deliver a large specific capacitance of 257 F g−1 (1428 mF cm−2 and 492 F cm−3) in neat EMIMTFSI electrolyte leading to high energy density. Quasi elastic neutron scattering and electrochemical impedance spectroscopy are used to study the dynamics of confined RTIL in pre‐intercalated MXene. Molecular dynamics simulations suggest significant differences in the structures of RTIL ions and AA cations inside the Ti3C2Tx interlayer, providing insights into the differences in the observed electrochemical behavior.

No abstract