A 10 mm narrow gap TC4 titanium alloy welded joint by laser welding with filler wire was obtained by different welding heat inputs. The microstructures of the welded joint were analyzed by OM, SEM, XRD and EBSD. The mechanical properties of the welded joint were analyzed by microhardness test and tensile test. The results show that with the increase of laser welding heat input, the average grain size and width of the equiaxed crystal zone in the center of the weld increases, the grain angle in the columnar crystal zone gradually tends to be perpendicular to the center of the weld, and the width of the heat affected zone (HAZ) increases without obvious grain coarsening. The HAZ of the welded joint is softened, and its microhardness value is lower than that of the weld and the base metal. The tensile strength of the welded joint is slightly higher than those of the base metal, but the elongation after fracture is less than that of the base metal, and it decreases with the increase of laser welding heat input.
The evolution of austenite, acicular ferrite, upper bainite and martensite, and the nucleation of inclusions in the microstructure of high-strength steel deposited metals, was systematically investigated using three kinds of A5.28 E120C-K4 metal-cored wires with various rare earth Pr contents. Grain structure evolution in the process of high temperature, dispersoid characteristics of inclusions and the crystallographic characteristics of the microstructure were assessed. Compared with no addition of Pr6O11, adding 1%Pr6O11 resulted in refined, spheroidized and dispersed inclusions in the deposited metal, leading to an increase in the pinning forces on the grain boundary movement, promoting the formation of an ultra-fine grain structure with an average diameter of 41 μm. The inclusions in the deposited metals were Mn-Si-Pr-Al-Ti-O after Pr addition; the average size of the inclusions in the Pr-containing deposited metals was the smallest, while the number and density of inclusions was the highest. The size of effective inclusions (nucleus of acicular ferrite formation) was mainly in the range of 0.6–1.5 μm. In addition, the content of upper bainite decreased, while the percentage of acicular ferrite increased by 24% due to the increase in the number of effective inclusions in the Pr-containing deposited metals in this study. This study shows that the addition of 1% Pr6O11 is efficient in achieving fine interlaced multiphase with an ultrafine-grained structure, resulting in an enhancement of the impact toughness of the deposited metal.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.