Prosthetic is an artificial tool that replaces part of the human frame absent because of ailment, damage, or distortion. The current activities in Iraq draw interest to the upper limb discipline because of the growth in variety of amputees and. It is necessary to do extensive researches in this subject to help lessen the struggling of patients. This paper describes the design and development of low-cost prosthesis for people with transradial amputations. The presented design involves a hand with five fingers moving by means of a gear box mechanism. The design of this artificial hand allows five degrees of freedom(5DOF), one degree of freedom for each finger. The artificial hand works by an actuation system (6V) Polou motor with gear ratio equal to 50:1 due to its compactness and cheapness. The designed hand was manufactured by a 3D printing process using polylacticacid material (PLA). Some experimental were accomplished using the designed hand for gripping objects. Initially the EMG signal was recorded when the muscle contracted in one second, two seconds, three seconds. The synthetic hand was able to produce range of gesture and grasping moves separately just like the actual hand by using KNN classification which are complete hand Pinch, fist, and jack chuck. The simulation of the fingers movements was achieved using ANSYS software to analysis the movement (pinch, fist, and jack chuck), obtain bested of stress influencer at each finger, and maximum deformation at each movement.
Prosthetic is an artificial tool that replaces a member of the human frame that is absent because of ailment, damage, or distortion. The current research activities in Iraq draw interest to the upper limb discipline because of the growth in the number of amputees. Thus, it becomes necessary to increase researches in this subject to help in reducing the struggling patients. This paper describes the design and development of a prosthesis for people able and wear them from persons who have amputation in the hands. This design is composed of a hand with five fingers moving by means of a gearbox ism mechanism. The design of this artificial hand has 5 degrees of freedom. This artificial hand works based on the principle of under actuated system. The used motor is 6V Polulu high-power carbon brush micro metal gearmotor with gear ratio equal to 50:1. The motor was chosen due to its compactness and cheapness. The hand manufacturing process was done using a 3D printer and using polylactic acid material. Numbers of experiments were accomplished using the designed hand for gripping objects. Initially, the electromyography signal (EMG) was recorded when the muscle contracted in one second, two seconds, three seconds. The synthetic hand was able to produce a range of gestures and grasping for objects.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.
hi@scite.ai
10624 S. Eastern Ave., Ste. A-614
Henderson, NV 89052, USA
Copyright © 2024 scite LLC. All rights reserved.
Made with 💙 for researchers
Part of the Research Solutions Family.