No abstract

Copper-coated graphite and copper mixture powders were deposited on AZ31B magnesium alloy and 6061 T6 aluminum alloy substrates under different process parameters by a solid-state cold spray technique. The microstructure of the copper-coated graphite and copper composite coatings was visually examined using photographs taken with an optical microscope and a scanning electron microscope. The surface roughness of the coatings was investigated with a 3D profilometer. The thickness of the coatings was determined through the analysis of the microstructure images, while the adhesion of the coatings was characterized using the scratch test method. The results indicate that the surface roughness of the coatings sprayed on the two different substrates gradually decreases as gas temperature and gas pressure increase. Additionally, the thickness and adhesion of the coatings deposited on the two different substrates both increase with an increase in gas temperature and gas pressure. Comparing the surface roughness, thickness, and adhesion of the coatings deposited on the two different substrates, the surface roughness and adhesion of the coatings on the soft substrate are greater than those of the coatings on the hard substrate, while the thickness of the coatings is not obviously affected by the hardness of the substrate. Furthermore, it is noteworthy that the surface roughness, thickness, and adhesion of the copper-coated graphite and copper composite coatings sprayed on the two different substrates exhibit a distinct linear relationship with particle velocity.

A solid-state cold-spray technique was employed for depositing the copper-coated graphite reinforced copper-based composite coatings on aluminum alloy 6061 T6 substrate under different process parameters. The optimum process parameters of the cold-sprayed coatings were predicted in terms of surface roughness, thickness and adhesion. The surface roughness was measured using a 3D profilometer, the thickness and element constitution were detected by an optical microscope and scanning electron microscope furnished with an energy-dispersive spectral analyzer and the adhesion was detected by the scratch test method. The microstructures of the deposited coatings were also observed by a scanning electron microscope. The results show that when the coating is not oxidized and dense, the copper-coated graphite reinforced copper-based composite coating at 800 °C, 5.5 MPa, possesses the lowest surface roughness, the maximum thickness and the highest adhesion among the cold-sprayed coatings. In addition, the surface roughness, thickness and adhesion of the deposited coatings are all linear with particle velocity.

The WC composite powder was synthesized by a new specific chemical activation technique. A large number of lattice defects such as surface humps, dislocations and stacking fault exist in the surface of the WC powder after chemical activation technique. By using such activated WC powder, the binderless WC cemented carbide with high density (15.54 g/cm3), super hardness (average 26.29 GPa) and excellent fracture toughness (8.9 MPa.m1/2) can be fabricated by SPS at 1700 °C and 50 MPa pressure. The improvement in density, hardness and fracture toughness are respectively 4.5%, 15.3% and 17.1% compared to when using the original WC powder. This improvement is because microscopic defects on the surface of the WC powder can greatly improve surface free energy of the powder, which improves the sintering activity and reduces the sintering temperature of the WC powder.

No abstract