Nowadays, with the advent of smartphones, most of people started to make voice and video conference calls continuously even in a high mobility scenario, the bandwidth requirements have increased considerably, which can cause network congestion phenomena. To avoid network congestion problems and to support high mobility scenario, 3GPP has developed a new cellular standard based packet switching, termed LTE (Long Term Evolution). The purpose of this paper is to evaluate the performance of the new proposed algorithm, named Exponential Modified Largest Weighted Delay First ‘EXP-MLWDF’, for high mobility scenario and with the presence of a large number of active users, in comparison with the well-known algorithms such as a proportional fair algorithm (PF), Exponential Proportional Fairness (EXP/PF), Logarithm Rule (LOG-Rule), Exponential Rule (EXP-Rule) and Modified Largest Weighted Delay First (MLWDF). The performance evaluation is conducted in terms of system throughput, delay and PLR. Finally, it will be concluded that the proposed scheduler satisfies the quality of service (QoS) requirements of the real-time traffic in terms of packet loss ratio (PLR), average throughput and packet delay. Because of the traffic evolution, some key issues related to scheduling strategies that will be considered in the future requirements are discussed in this article.
The impending next generation of mobile communications denoted 5G intends to interconnect user equipment, things, vehicles, and cities. It will provide an order of magnitude improvement in performance and network efficiency, and different combinations of use cases enhanced mobile broadband (eMBB), ultra reliable low latency communications (URLLC), massive internet of things (mIoT) with new capabilities and diverse requirements. Adoption of advanced radio resource management procedures such as packet scheduling algorithms is necessary to distribute radio resources among different users efficiently. The proportional fair (PF) scheduling algorithm and its modified versions have proved to be the commonly used scheduling algorithms for their ability to provide a tradeoff between throughput and fairness. In this article, the buffer status is combined with the PF metric to suggest a new scheduling algorithm for efficient support for eMBB. The effectiveness of the proposed scheduling strategy is proved through à comprehensive experimental analysis based on the evaluation of different quality of service key performance indicators (QoS KPIs) such as throughput, fairness, and buffer status.
This paper presents the study and design of a balanced voltage controlled oscillator VCO for 5G wireless communication systems. This circuit is designed in monolithic microwave integrated circuit (MMIC) technology using PH15 process from UMS foundry. The VCO ensures an adequate tuning range by a single-ended pHEMT varactors configuration. The simulation results show that this circuit delivers a sinusoidal signal of output power around 9 dBm with a second harmonic rejection between 25.87 and 33.83 dB, the oscillation frequency varies between 26.46 and 28.90 GHz, the phase noise is -113.155 and -133.167 dBc/Hz respectively at 1 MHz and 10 MHz offset and the Figure of Merit is -181.06 dBc/Hz. The power consumed by the VCO is 122 mW. The oscillator layout with bias and RF output pads occupies an area of 0.515 mm2.
Among other CubeSat subsystems, Antenna is one of the most important CubeSat components as its design determines all the telecommunication subsystems’ performances. This paper presents a coplanar wave-guide (CPW)-fed equilateral triangular slot antenna constructed and analyzed for CubeSat communications at S-band. The proposed antenna alone presents high gain and ultra-wide band while its radiation pattern is bidirectional at an unlicensed frequency of 2450 MHz. The objective is to use the CubeSat chassis as a reflector for reducing the back-lobe radiation and hence minimizing interferences with electronic devices inside the CubeSat. This leads to a high gain of 8.20 dBi and a unidirectional radiation pattern at an industrial, scientific and mdical (ISM) band operating frequency of 2450 MHz. In addition to that, the presented antenna is low-profile and exhibits high return loss, ultra-wide impedance bandwidth, and good impedance matching at 2450 MHz.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.