316L stainless steel samples have been prepared by selective laser melting (SLM) using a pulsed laser mode and different laser powers and scanning patterns. The as-fabricated samples were found to be dominated by clusters of nano-sized γ needles or cells. TEM imaging shows that these needles contain a high population of dislocations while TEM-EDX analysis reveals high chemical homogeneity throughout the as-fabricated samples as evidenced by the fact that there is even no micro-/nano-segregation at interfaces between neighbouring γ needles. The good chemical homogeneity is attributed to the extremely high cooling rate after SLM (>106 °C/s) and the formation of Si- and Mn-oxides that distribute randomly in the current samples. The laser-processed samples show both superior strength and ductility as compared with conventionally manufactured counterparts. TEM examination on the deformed specimens reveals a significantly high density of dislocations and a great number of twinning within nano-needles, suggesting that the plastic deformation has been governed by both gliding of dislocations and twinning deformation, which is believed to be responsible for the simultaneous acquisition of superior strength and ductility. Finally, laser power shows a much more dominant role than laser scanning pattern in porosity and grain size development for the SLM-processed 316L stainless steel samples.

Mandible defects and its deformities are serious complications and its precise reconstruction is one of the most challenging tasks in oral maxillofacial surgery. The commercially available standard mandible implants are manually bended before surgery to custom fit the patient's jaw. A slight mismatch in the plate and bone alignment may result in the implant failure. However, with the integration of computer-aided design, rapid prototyping, and advanced imaging systems (computed tomography or magnetic resonance imaging), it is possible to produce a customized mandible implant that can precisely fit the patient's jaw. The aim of this article is to compare a new design of customized mandible implant (sinewave plate) and compare it with the commonly used straight implant design. The finite element-simulated results reveal that the commonly used straight reconstruction plates are more prone to loosening of the screws due to its higher strain concentration on the screw hole when compared to newly designed sinewave reconstruction plate. Moreover, the straight plate is more sensitive to the chewing load variations and develops almost 20% increase in the stresses when compared to sinewave plate. The study reveals that the sinewave reconstruction plate can significantly enhance the stability and safety of the mandible implant.

We present the results of the geomorphological mapping of a region of the Dhofar (Sultanate of Oman) including two contrasting physiographic units sharing a common drainage system into the Arabian Sea: the Jebel Qara limestone massif and the coastal plain of Salalah. Neogene to Quaternary tectonic activity controlled the formation of an extensive system of faults and caused the uplift of the Jebel Qara, forming structural escarpments. The massif underwent karstification and subsequent linear erosion. Today the Jebel is cut by a dendritic net of dry valleys, occasionally dammed by calcareous tufa dams. The transition between the southern escarpment of the Jebel and the plain below displays flat alluvial fans, bordered by a strip of beachrock, coastal dunes, and coastal lagoons, located in correspondence to estuaries. Dramatic soil erosion is evident, linked to intense human-triggered zoogeomorphological processes started in the Mid-Late Holocene after the introduction of pastoral land-use. ARTICLE HISTORY

No abstract

No abstract