No abstract

No abstract

SUMMARY Reinforced concrete columns with insufficient transverse reinforcement and non‐seismic reinforcement details are vulnerable to brittle shear failure and to loss of axial load carrying capacity in the event of a strong earthquake. In this paper, a procedure is presented after examining the application of two macro models for displacement‐based analysis of reinforced concrete columns subjected to lateral loads. In the proposed model, lateral load‐deformation response of the column is simulated by estimating flexural and shear deformation components separately while considering their interaction and then combining these together according to a set of rules depending upon column's yield, flexural and shear strengths. In addition, lateral deformation caused by reinforcement slip in beam–column joint regions and buckling of compression bars are taken into account and considered in the analysis. Implementation of the proposed procedure produces satisfactory lateral load–displacement relationships, which are comparable with experimental data. Copyright © 2012 John Wiley & Sons, Ltd.

The Far-Eastern Himalaya Landscape (FHL), a shared transboundary landscape between China, India, and Myanmar, is one of the most intact and biologically rich landscapes in the Eastern Himalaya. Yet, the state of biodiversity and its significance are comparatively poorly known to conservationists and policy makers due to low priority in research, inaccessibility, and remoteness. We collated and reviewed 1032 articles relating to biodiversity of the FHL to understand research trends, identify knowledge gaps, and suggest priority research areas for future biodiversity conservation and management in the landscape. Our review showed that the Myanmar part of the landscape is the most studied, followed by the Indian and Chinese parts. The trend of publications in the landscape showed that the earliest publication on biodiversity in the FHL dates back to 1833, while the years from 2001 to 2017 account for almost 80% of the total publications. Most studies focused on species (73.6%), followed by ecosystems (25%) and genetics (1.4%). Mammals were the most studied taxa (22.6%), with a greater focus on charismatic megafauna, followed by arthropods (15.6%), angiosperms (14.8%), insects (13.4%), and birds (10.8%). There were very few publications on lower invertebrates and lower kingdoms, Monera, Protista, Fungi, and Viruses. At the ecosystem level, most studies focused on forests (58.5%) followed by freshwater (32%), agroecosystems (9%), and alpine/tundra ecosystem (0.5%); there were only 14 studies at genetic level. In the FHL, new species have been discovered and rediscovered starting from the early 1930s until 2017. The majority of newly discovered species in the last 18 years are arthropods. The paper reviews past research areas, identifies gaps for future research and intervention, and recommends transboundary collaboration to address these gaps for conservation and sustainable development of the FHL landscape.

This article describes the development of a mathematical model of forward roll coating of a thin film of a non-Newtonian material when it passes through a small gap between the two counter-rotating rolls. The conservation equations of mass, momentum, and energy in the light of LAT (lubrication approximation theory) are non-dimensionalized and solutions for the velocity profile, flow rate, pressure distribution, pressure, forces, stresses, power input to the roller, and temperature distribution are calculated analytically. It is found that by changing (increasing/decreasing) the value of material parameters, one can really control the engineering parameters like, stress and the most important the coating thickness and is a quick reference for the engineer working in coating industries. Some results are shown graphically. From the present study, it has been established that the material parameter is a device to control flow rate, coating thickness, separation points, and pressure distribution.