In the design of electron-transport layers (ETLs) to enhance the efficiency of planar perovskite solar cells (PSCs), facile electron extraction and transport are important features. Here, we consider the effects of different titanium oxide (TiO2) polymorphs, anatase and brookite. We design and fabricate high-phase-purity, single-crystalline, highly conductive, and low-temperature (<180 °C)-processed brookite-based TiO2 heterophase junctions on fluorine-doped tin oxide (FTO) as the substrate. We test and compare single-phase anatase (A) and brookite (B) and heterophase anatase–brookite (AB) and brookite–anatase (BA) as ETLs in PSCs. The power-conversion efficiencies (PCEs) of PSCs with low-temperature-processed single-layer FTO-B as the ETL were as high as 14.92%, which is the highest reported efficiency of FTO-B-based single-layer PSC. This implies that FTO-B serves as an active phase and can be a potential candidate as an n-type ETL scaffold in planar PSCs. Moreover, the surface of highly crystalline brookite TiO2 exhibits a tendency toward interparticle necking, leading to the formation of compact scaffolds. Furthermore, PSCs with heterophase junction FTO-AB ETLs exhibited PCEs as high as 16.82%, which is superior to those of PSCs with single-phase anatase (FTO-A) and brookite (FTO-B) as the ETLs (13.86% and 14.92%, respectively). In addition, the PSCs with FTO-AB exhibited improved efficiency and decreased hysteresis compared with those with FTO-BA (13.45%) due to the suitable band alignment with the perovskite layer, which resulted in superior photogenerated charge-carrier extraction and reduced charge accumulation at the interface between the heterophase junction and perovskite. Thus, the present work presents an effective strategy by which to develop heterophase junction ETLs and manipulate the interfacial energy band to further improve the performance of planar PSCs and enable the clean and eco-friendly fabrication of low-cost mass production.

Electron-transport layer (ETL)/perovskite interface modification plays a key task for producing efficient planar perovskite solar cells (PSCs). In this study, interfacial modification of compact TiO2 using novel, one-step hydrothermally synthesized single-crystalline anatase (AT) titania nanoparticles (TiO2 NPs) (average diameter = 6–10 nm) was applied as an ETL bilayer to enhance the efficient charge generation and extraction and eliminate the electron–hole recombination ratio. We report here an easy approach for enhancing the performance of planar PSCs by introducing a compact TiO2/AT TiO2 NPs bilayer through spray pyrolysis (SP) deposition and spin-coating (SC) techniques, respectively. The enhanced performance of the devices with an SP-TiO2/SC-AT TiO2 NPs bilayer facilitated more efficient electron transport, charge extraction, and low interfacial recombination. Ultimately, the best device had a 17.05% power conversion efficiency resulting from the significant decrease in J–V hysteresis, presenting almost a 12% performance improvement compared to the TiO2 only layer-based counterpart. Thus, the present study provides an important advance to the design of photovoltaic devices with respect to charge transport and electron–hole recombination.

No abstract

No abstract

No abstract