Solid-state nanopores have been studied widely for the label-free analysis of single biomolecules. The translocation of charged biomolecules through a solid-state nanopore is driven by the applied voltage across a thin membrane. The ionic current changes in response to the translocation of DNA through the nanopore. Solid-state nanopores have many advantages over biological nanopores, such as α-hemolysin and MspA, but the high DNA translocation velocity and the inherent noise in solid-state nanopores have hindered its applications to more precise measurements, such as DNA sequencing. This paper reports a simple and reproducible way of passivating the surface of a nanopore device using an insulating layer, photodefinable PDMS (P-PDMS), to reduce noise and enhance the accuracy of the electrical measurements. This new approach does not require a separate photo-mask or sophisticated micro-alignment equipment to pattern the insulating layer. The pit structure on the back side of the support chip serves as a mask, enabling mask-free photolithography, and the insulating layer only on top of the free-standing silicon nitride membrane can be irradiated selectively by UV and removed by subsequent development in toluene. The resulting nanopore device with a small free standing silicon nitride membrane surrounded by a thick insulating layer showed improved noise characteristics. The root-mean-square noise of the ionic current was reduced to 3.8 pA from 90.8 pA by the formation of a micron-thick insulating layer. The overall performance of the nanopores with an insulating layer was improved significantly when tested with the double-stranded DNA (λ-DNA).
Articles you may be interested inActive-matrix nanocrystalline Si electron emitter array with a function of electronic aberration correction for massively parallel electron beam direct-write lithography: Electron emission and pattern transfer characteristics J. Vac. Sci. Technol. B 31, 06F703 (2013); 10.1116/1.4827819 Long nanoscale gaps on III-V substrates by electron beam lithography J. Vac. Sci. Technol. B 30, 06F305 (2012); 10.1116/1.4766881 Tilted nanostructure fabrication by electron beam lithography J. Vac. Sci. Technol. B 30, 06F302 (2012); 10.1116/1.4754809 Fabrication of nanodot array molds by using an inorganic electron-beam resist and a postexposure bakeThe authors fabricated 15 nm pitch scale high-density dot patterns on a Si substrate using a hydrogen silsesquioxane electron-beam (e-beam) resist, vacuum treatment as a prebake, and vertical sidewall etching. The e-beam lithography was performed at 100 keV. The dot density fabricated was close to 3 Tbits/in., 2 which is one of the highest density patterns reported thus far. The process window was quite wide and the result can be easily and routinely duplicated.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.
hi@scite.ai
10624 S. Eastern Ave., Ste. A-614
Henderson, NV 89052, USA
Copyright © 2024 scite LLC. All rights reserved.
Made with 💙 for researchers
Part of the Research Solutions Family.