A novel LED fishing/working light is proposed to enhance the lighting efficiency of a fishing boat. The study is focused on the freeform secondary lens design so as to create a lamp that attracts fish and sheds light on the deck for the crew's work. The experimental results show that the proposed multisegmented freeform lens can deliver the proposed aim, giving 3 times as much illuminating power as the traditional high-intensity discharge fishing lamp does with the same input of electrical power.
The study is focused on the asymmetric secondary freeform lens (ASFL) design for creating a low glared light-emitting diode (LED) street light. The lens is mounted on a chip on board (COB) LED as the new LED street light module to perform a non-axial symmetric light intensity distribution. The experimental results show that the street light can work without inclining lamps and reach Chinese National Standards (CNS) and Illuminating Engineering Society of North America (IESNA) standards at the same time.
A free-form secondary lens is proposed to optimize an LED light. Based on Snell's law, energy conservation law, and a Monte Carlo ray-tracing algorithm, the surface contour of the free-form lens can be determined according to the requirements of an LED light. Optical experimental results show that an optical efficiency of 95.69% can be achieved by the lens, of which the illumination uniformity 0.317 is higher than the commercial illumination uniformity 0.259. The lens does not need the help of a white ring holder, so the cost of the LED light can become effective.
This study proposed a triple-layer remote phosphor (TRP) structure to improve the color and luminous flux of white LEDs (WLEDs). TRP structure consists of 3 different phosphor layers: yellow YAG:Ce3+ layer below, red CaMgSi2O6:Eu2+,Mn2+ phosphor on top and green layer Ba2Li2Si2O7:Sn2+,Mn2+ phosphor in the middle. Using red CaMgSi2O6:Eu2+,Mn2+ to control the red light component leads to increased color rendering index (CRI). Utilize the green CaMgSi2O6:Eu2+,Mn2+ phosphor to control the green light component results in the increase in luminous efficacy (LE) of WLEDs. Furthermore, when the concentration of these two phosphors increased, yellow layer concentration YAG:Ce3+ decreased to maintain average correlated color temperatures (ACCTs) in the range from 6000 K-8500K. Besides CRI and LE, color quality scale (CQS) is also analyzed through concentration control of green phosphor and red phosphor. The research results show that the higher the concentration of CaMgSi2O6:Eu2+,Mn2+, the better for CRI. In contrast, CRI decreased significantly when increasing the concentration of Ba2Li2Si2O7:Sn2+,Mn2+. Meanwhile, CQS achieve notable enhancement in the concentration range of 10% -14% CaMgSi2O6:Eu2+,Mn2+, regardless of Ba2Li2Si2O7:Sn2+,Mn2+ concentration. LE, in particular, can also increase by more than 40% along with the improvement of CRI and CQS with the reduction of the backscattered light and addition of green light. Research results are a valuable reference for producers who wish to improve the color quality and enhance the luminous flux of WLEDs. This is an Open Access article distributed under the terms of the Creative Commons Attribution License (http://creativecommons.org/licenses/by/4.0/), which permits unrestricted use, distribution, and reproduction in any medium provided the original work is properly cited.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.