No abstract

The present study deals with the development of a liquid microextraction procedure for enhancing the sensitivity of the determination of 2-methyl-4-isothiazolin-3-one and 5-chloro-2-methyl-4-isothiazolin-3-one in adhesives. The procedure involves a three-phase hollow-fiber liquid-phase microextraction using a semipermeable polypropylene membrane, which contained 1-octanol as the organic phase in the pores of the membrane. The donor and acceptor phases are aqueous acidic and alkaline media, respectively, and the final liquid phase (acceptor) is analyzed by HPLC coupled with diode array detection. The most appropriate conditions were extraction time 20 min, stirring speed 1400 rpm, extraction temperature 50°C. The quantification limits of the method were 0.123 and 0.490 μg/g for 2-methyl-4-isothiazolin-3-one and 5-chloro-2-methyl-4-isothiazolin-3-one, respectively. Three different adhesive samples were successfully analyzed. The procedure was compared to direct analysis using ultra high pressure liquid chromatography coupled with TOF-MS, where the identification of the compounds and the quantification values were confirmed.

No abstract

No abstract

No abstract

In this study, the viability of applying cork and montmorillonite clay modified with ionic liquid as biosorbents in the rotating-disk sorptive extraction technique was investigated. Specifically, this was aimed at the determination of methyl paraben, ethyl paraben, propyl paraben, and isobutyl paraben, with separation/determination by high-performance liquid chromatography coupled with mass spectrometry. The optimization of the method for both biosorbents was performed using multivariate procedures. The extraction efficiencies for the target compounds in aqueous matrices were compared to those obtained using the commercial sorbent Octadecil Silano-C18. The optimum extraction conditions for both natural sorbents were the use of an ammonia solution (pH 10) as desorption solvent and an extraction time of 30 min. The proposed methods show limits of quantification of 0.8 μg/L for cork, 3.0 μg/L for montmorillonite clay and 6.0 μg/L for Octadecil Silano-C18. The relative recoveries from river water and tap water samples ranged from 80.3 to 118.7% and 80.0 to 119.9% for cork and montmorillonite clay modified with ionic liquid, respectively. Relative standard deviations were obtained for intra- and interday precisions of <15% and <19% for cork and <19% and <17% for montmorillonite clay modified with ionic liquid.

No abstract

No abstract