Electropolishing (EP) is a reliable post-processing method of the drilled metals for achieving a high-quality surface finish with an appropriate material removal rate. This process has many applications due to its advantages such as improving the surface quality by removing the surface peaks on a micro-scale. The aim of most attempts on this process is setting up the optimum parameters to obtain maximum Material Removal Rate (MRR) with minimum surface roughness. In the present wo k, electropolishing of AISI 4340 low alloy steel immersed in eco-friendly NaCl solution has been studied numerically and experimentally. So, primarily a simulation model was developed for the EP process on cylinder parts in COMSOL Multiphysics which was validated with experimental approaches. The results revealed that the numerical model would be convenient for EP. The experiments were performed using Response Surface Methodology (RSM) to evaluate the effect of input variables on the responses. The effects of input variables electrolyte temperature, current intensity, and primary gap were investigated on the outputs MRR and surface roughness at five levels. Based on the results, the electrolyte temperature and current intensity were more effective parameters on the outputs. Results of ANOVA and regression analysis approach revealed that by increasing the current and electrolyte temperature, the MRR increases correspondingly and surface roughness declines and the primary gap has a reverse effect on the MRR. Finally, by performing a multi-objective optimization using Derringer’s desirability approach, the EP of AISI 4340 with an eco-friendly NaCl solution was optimized.
This study involves the validating of thermal analysis during TIG Arc welding of 1.4418 steel using finite element analyses (FEA) with experimental approaches. 3D heat transfer simulation of 1.4418 stainless steel TIG arc welding is implemented using ABAQUS software (6.14, ABAQUS Inc., Johnston, RI, USA), based on non-uniform Goldak’s Gaussian heat flux distribution, using additional DFLUX subroutine written in the FORTRAN (Formula Translation). The influences of the arc current and welding speed on the heat flux density, weld bead geometry, and temperature distribution at the transverse direction are analyzed by response surface methodology (RSM). Validating numerical simulation with experimental dimensions of weld bead geometry consists of width and depth of penetration with an average of 10% deviation has been performed. Results reveal that the suggested numerical model would be appropriate for the TIG arc welding process. According to the results, as the welding speed increases, the residence time of arc shortens correspondingly, bead width and depth of penetration decrease subsequently, whilst simultaneously, the current has the reverse effect. Finally, multi-objective optimization of the process is applied by Derringer’s desirability technique to achieve the proper weld. The optimum condition is obtained with 2.7 mm/s scanning speed and 120 A current to achieve full penetration weld with minimum fusion zone (FZ) and heat-affected zone (HAZ) width.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.