This paper presents a transport and recovery of silver ions through bulk liquid membranes based on n–decanol using as carriers 10–undecylenic acid and 10–undecylenyl alcohol. The transport of silver ions across membranes has been studied in the presence of two types of magnetic oxide nanoparticles obtained by the electrochemical method with iron electrodes in the electrolyte with and without silver ions, which act as promoters of turbulence in the membrane. Separation of silver ions by bulk liquid membranes using 10–undecylenic acid and 10–undecylenyl alcohol as carriers were performed by comparison with lead ions. The configuration of the separation module has been specially designed for the chosen separation process. Convective-generating magnetic nanoparticles were characterized in terms of the morphological and structural points of view: scanning electron microscopy (SEM), high-resolution SEM (HR–SEM), energy dispersive spectroscopy analysis (EDAX), Fourier Transform InfraRed (FTIR) spectroscopy, thermal gravimetric analysis (TGA), differential scanning calorimetry and magnetization. The process performance (flux and selectivity) was tested were tested for silver ion transport and separation through n–decanol liquid membranes with selected carriers. Under the conditions of the optimized experimental results (pH = 7 of the source phase, pH = 1 of the receiving phase, flow rate of 30 mL/min for the source phase and 9 mL/min for the receiving phase, 150 rot/min agitation of magnetic nanoparticles) separation efficiencies of silver ions of over 90% were obtained for the transport of undecenoic acid and about 80% for undecylenyl alcohol.

No abstract

Radon gas is the largest source of public exposure to naturally occurring radioactivity. However, radon is also a useful tracer for understanding atmospheric processes, assessing the accuracy of chemical transport models, and enabling integrated emissions estimates of greenhouse gases. A sound metrological system for low level atmospheric radon observations is therefore needed for the benefit of the atmospheric, climate and radiation protection research communities. To this end, here we present a new calibration method for activity concentrations below 20 Bq m−3 and a prototype of the first portable radon monitor capable of achieving uncertainties of 5% (at k = 2) at these concentrations. Compliance checking of policy-driven regulations regarding greenhouse gas (GHG) emissions is an essential component of climate change mitigation efforts. Independent, reliable ‘top down’ methods that can be applied consistently for estimating local- to regional-scale GHG emissions (such as the radon tracer method (RTM)) are an essential part of this process. The RTM relies upon observed radon and GHG concentrations and measured or modeled radon fluxes. Reliable radon flux maps could also significantly aid EU member states comply with European COUNCIL DIRECTIVE 2013/59/EURATOM. This article also introduces the traceRadon project, key aims of which include outlining a standardized approach for application of the RTM, creating infrastructure with a traceability chain for radon concentration and radon flux measurements, and developing tools for the validation of radon flux models. Since radon progeny dominate the terrestrial gamma dose rate, the planned traceRadon activities are also expected to improve the sensitivity of radiation protection early warning networks because of the correlation known to exist between radon flux and ambient equivalent dose rates.

Liquid membranes usually have three main constructive variants: bulk liquid membranes (BLM), supported liquid membranes (SLM) and emulsion liquid membranes (ELM). Designing hybrid variants is very topical, with the main purpose of increasing the flow of substance through the membrane but also of improving the selectivity. This paper presents the operational limits of some kind of hybrid membrane constituted as a bulk liquid membrane (BLM), but which works by dispersing the aqueous source (SP) and receiving (RP) phases, with the membrane itself being a dispersion of nanoparticles in an organic solvent (NP–OSM). The approached operational parameters were the volume of phases of the hybrid membrane system, the thickness of the liquid membrane, the working temperature, the flow of aqueous phases, the droplet size of the aqueous phases dispersed across the membrane, the nature and concentration of nanoparticles in the membrane, the pH difference between the aqueous phases, the nature of the organic solvent, the salt concentration in the aqueous phases and the nature of transported chemical species. For this study, silver ion (SI) and p-nitrophenol (PNP) were chosen as transportable chemical species, the n-aliphatic alcohols (C6…C12) as membrane organic solvents, 10–undecenoic acid (UDAc) and 10-undecylenic alcohol (UDAl) as carriers and magnetic iron oxides as nanoparticles dispersed in the membrane phase. Under the experimentally established operating conditions, separation efficiencies of over 90% were obtained for both ionic and molecular chemical species (silver ions and p-nitrophenol). The results showed the possibility of increasing the flow of transported chemical species by almost 10 times for the silver ion and approximately 100 times for p-nitrophenol, through the appropriate choice of operational parameters, but they also exposed their limits in relation to the stability of the membrane system.

No abstract