Active optical sensors (AOSs) measure crop refl ectance at specifi c wavelengths and calculate vegetation indices (VIs) that are used to prescribe variable N fertilization. Visual observations of winter wheat (Triticum aestivum L.) plant greenness and density suggest that VI values may be genotype specifi c. Some sensor systems use correction coeffi cients to eliminate the eff ect of genotype on VI values. Th is study was conducted to assess the eff ects of winter wheat cultivars and growing conditions on canopy refl ectance, as measured by red or amber normalized diff erence vegetative indices (NDVIs) derived from AOSs. Variations in NDVI values among three wheat cultivars were measured at three growth stages (Zadoks 31, 37, and 65) during 3 yr at three sites in Poland. GreenSeeker Model 505 and Crop Circle ACS-210 sensors were utilized to measure red and amber NDVIs, respectively. Signifi cant (p < 0.05) diff erences in both forms of NDVI associated with wheat genotypes were observed across years and sites at Zadoks 31, the time when canopy sensing and N fertilization decisions are oft en made. Lack of a genotype ´ site interaction for both red and amber NDVIs and the presence of a signifi cant genotype ´ year interaction for both VIs suggested that (i) canopy greenness and density of the same genotype measured at the same growth stage are likely to be stable across diff erent growing conditions, and (ii) NDVI values for a particular genotype tend to vary more across years than across sites. Because developing temporally variable correction coeffi cients is not practical, we strongly recommend that an in situ calibration (based on in-fi eld or a virtual reference strip) is utilized to normalize NDVI across genotypes, years, and sites.

Soil texture (ST) is relatively stable over time, although it may change due to erosion, clay eluviation, and other processes. Soil texture affects soil quality, productivity and management. Therefore, indirect, accurate methods for assessing of soil texture classes (STCs) are needed in agricultural practice. A study was performed on four production fields in northern and central Poland to compare the fitting performance of STC models based on apparent electrical conductivity (ECa), topographic properties (elevation, slope gradient and wetness index) and Amber NDVI measurements. One common and accurate indicator of STCs was not found for all study fields. On average, ECa was most accurate in indicating areas of different STCs within the fields, but it tended to overestimate the size of sandy areas on loamy fields and vice versa. The accuracy of STC assessment using ECa measurements may be biased due to imperfect soil drainage, high elevations, which increase evaporation and STC variation with depth. STC assessment using Amber NDVI measurements may be useful, particularly on flat and sandy fields, but the results are affected by the same factors as ECa, and additionally by crop growth stages and by the weather conditions in the period preceding the measurements. Despite the good quantitative results of the STC assessment by elevation (one field) and by the topographic wetness index (another field), both terrain attributes failed to accurately indicate the distribution of some STC areas within each field. Therefore, in landscapes developed from deposits of the last glaciation relevant ST differences might not sufficiently be detected by the analysis of terrain attributes alone. The selection of STC predictors and evaluation of the assessment quality must consider both the quantitative indicators such as correlation and determination coefficients describing relationships between ST and ECa, NDVI and topography and percentage of a field area with accurately indicated STC and the distribution of areas with different STCs within a field. The use of ECa, NDVI values, and topographic properties for STC assessment may be useful in reducing costs of soil sampling and analysis, but cannot replace it.

Soil testing is used to help make fertilizer recommendations for greater yields and profits. But the increase of soil-sampling density raises costs of sample collection and analyses. The aim of this study was to compare grid-cell sampling densities (1, 2, and 4 ha) in terms of the estimation accuracy of macronutrients (P, K, Mg) availability and pH and to investigate how sampling density affects the amount of fertilizers and lime recommended and correctly applied to winter wheat (Triticum aestivum L.). The distribution of liming requirements and available nutrients were quite similar for the 1-and 2-ha grids but notably different for the 4-ha grid. However, the whole-field average values of pH and P, K, and Mg concentrations in soil obtained for different sampling densities were very similar, thus placing, respectively, the soil of the studied area in the same class of liming needs and nutrient availability. The range and estimation errors of these parameters decreased with sampling-grid size increase. The amount of lime and fertilizers to be applied on the field and the portion of a field correctly limed or fertilized depended on the soil chemical property considered. If one treats the 1-ha grid as the reference and the most correct soil-sampling approach, 2-ha grid offered the greatest part of the field to be adequately fertilized with lime, P, and K. However, fertilization with Mg was much more appropriate if the recommendation was based on 4-ha, than on a 2-ha soil-sampling grid. To gain an insight into soil variation and soil process occurring at small scale, laboratory and geostatistical analyses on individual soil samples may be necessary in some cases. Possibly, such costly research can deliver relevant information which could be then applied into farmer's practice.

No abstract

A proper understanding of cultivar adaptation to different environments is of great relevance in agronomy and plant breeding. As wheat is the most important crop in Poland, with a total of about 22% of the total sown area, the study of its performance in environments with different productivity levels for consequent cultivar recommendation is of major importance. In this paper, we assess the relative performance of winter wheat cultivars in environments with different productivity and propose a method for cultivar recommendation, by considering the information of environmental conditions and drought stress. This is performed in the following steps: (1) calculation of expected wheat productivity, depending on environmental factors, (2) calculation of relative productivity of cultivars in the environments, and (3) recommendation of cultivars of a specific type and range of adaptation. Soil and weather conditions were confirmed as the most important factors affecting winter wheat yield. The weather factors should be considered rather in shorter (e.g., 10 day) than longer (e.g., 60 day) time periods and in relation to growth stages. The ANCOVA model with genotype and management intensity as fixed factors, and soil and weather parameters as covariates was proposed to assess the expected wheat productivity in particular environments and the expected performance of each genotype (cultivar). The recommendation of cultivars for locations of specified productivity was proposed based on the difference between the expected cultivar yield and the mean wheat productivity, and compared with the Polish official cultivar recommendation list.

Soil texture was examined in four crop fields with areas of 10 to 45 ha located in northern and central Poland. In each field, from 21 to 60 soil samples were collected using stratified sampling. The content (%) of soil particles, i.e., sand, silt and clay, was then evaluated using laboratory methods. The apparent electrical conductivity (ECa) was measured and used as ancillary data for the interpolation of soil texture. The obtained data were used to compare selected spatial interpolation methods according to the accuracy of prediction. The examined methods were evaluated based on the results of cross-validation tests. Two methods of validation were used: leave-oneout cross-validation and validation based on a test set of points, with approximately 30% randomly selected. The smallest root mean square error (RMSE) for the prediction of sand, silt and clay was observed for ordinary cokriging in which ECa was used as a covariate. The other three methods, i.e., inverse distance weighting, radial basis functioning and ordinary kriging, had very similar RMSE values, which were approximately 10% higher compared to ordinary cokriging.

The aims of this study were to: (i) evaluate the relationships between vegetation indices (VIs) derived from Sentinel-2 imagery and grain yield (GY) and the number of spikes per square meter (SN) of winter wheat and triticale; (ii) determine the dates and plant growth stages when the above relationships were the strongest at individual field scale, thus allowing for accurate yield prediction. Observations of GY and SN were performed at harvest on six fields (three locations in two seasons: 2017 and 2018) in three regions of Poland, i.e., northeastern (A—Brożówka), central (B—Zdziechów) and southeastern Poland (C—Kryłów). Vegetation indices (Normalized Difference Vegetation Index (NDVI), Soil-Adjusted Vegetation Index (SAVI), modified SAVI (mSAVI), modified SAVI 2 (mSAVI2), Infrared Percentage Vegetation Index (IPVI), Global Environmental Monitoring Index (GEMI), and Ratio Vegetation Index (RVI)) calculated for sampling points from mid-March until mid-July, covering within-field soil and topographical variability, were included in the analysis. Depending on the location, the highest correlation coefficients (of about 0.6–0.9) for most of VIs with GY and SN were obtained about 4–6 weeks before harvest (from the beginning of shooting to milk maturity). Therefore, satellite-derived VIs are useful for the prediction of within-field cereal GY as well as SN variability. Information on GY, predicted together with the results for soil nutrient availability, is the basis for the formulation of variable fertilize rates in precision agriculture. All examined VIs were similarly correlated with GY and SN via the commonly used NDVI. The increase in NDVI by 0.1 unit was related to an average increase in GY by about 2 t ha−1.

No abstract