No abstract

A set of stilbene-substituted octasilicates [p-RStil(x)Ph(8-x)SiO(1.5)](8) (R = H, Me, MeO, Cl, NMe(2) and x = 5.3-8) and [o-MeStilSiO(1.5)](8) were prepared. Model compounds were also prepared including the corner and half cages: [p-MeStilSi(OEt)(3)], [p-Me(2)NStilSi(OSiMe(3))(3)], and [p-Me(2)NStilSi(O)(OSiMe)](4). These compounds were characterized by MALDI-TOF, TGA, FTIR, and (1)H NMR techniques. Their photophysical properties were characterized by UV-vis, two-photon absorption, and cathodoluminescence spectroscopy (on solid powders), including studies on the effects of solvent polarity and changes in concentration. These molecules are typically soluble, easily purified, and robust, showing T(d(5%)) > 400 degrees C in air. The full and partial cages all show UV-vis absorption spectra (in THF) identical to the spectrum of trans-stilbene, except for [o-MeStilSiO(1.5)](8), which exhibits an absorption spectrum blue-shifted from trans-stilbene. However, the partial cages show emissions that are red-shifted by approximately 20 nm, as found for stilbene-siloxane macrocycles, suggesting some interaction of the silicon center(s) with the stilbene pi* orbital in both the corner and half cages. In contrast, the emission spectra of the full cages show red-shifts of 60-100 nm. These large red-shifts are supported by density functional theoretical calculations and proposed to result from interactions of the stilbene pi* orbitals with a LUMO centered within the cage that has 4A(1) symmetry and involves contributions from all Si and oxygen atoms and the organic substituents. Given that this LUMO has 3-D symmetry, it appears that all of the stilbene units interact in the excited state, consistent with theoretical results, which show an increased red-shift with an increase in the functionalization of a single corner to functionalization of all eight corners with stilbene. In the case of the Me(2)N- derivatives, this interaction is primarily a charge-transfer interaction, as witnessed by the influence of solvent polarity on the emission behavior. More importantly, the two-photon absorption behavior is 2-3 times greater on a per p-Me(2)Nstilbene basis for the full cage than for the corner or half cages. Similar observations were made for p-NH(2)stilbenevinyl(8)OS cages, where the greater conjugation lengths led to even greater red-shifts (120 nm) and two-photon absorption cross sections. Cathodoluminescence studies done on [p-MeStilSiO(1.5)](8) or [p-MeStilOS](8) powders exhibit essentially the same emissions as seen in solution at high dilution. Given that only the emissions are greatly red-shifted in these molecules, whereas the ground-state UV-vis absorptions are not changed from trans-stilbene, except for the ortho derivative, which is blue-shifted 10 nm. It appears that the interactions are only in the excited state. Theoretical results show that the HOMO and LUMO states are always the pi and pi* states on the stilbene, which show very weak shifts with increasing degrees of functionalization, consistent with the small chan...

The cubic symmetry of octafunctional octaphenylsilsesquioxanes [ROPS, (RC6H4SiO(1.5))8] coupled with a 1 nm diameter offers exceptional potential to assemble materials in three dimensions with perfect control of periodicity and the potential to tailor global properties at nanometer length scales. OPS itself is very inert and insoluble and can only be functionalized via electrophilic reactions with difficulty and with poor substitutional selectivity. However, functionalized OPS products are robust and highly soluble, offering easy purification and processing. In contrast to previous studies, we report here that OPS reacts with ICl at sub-ambient temperatures to provide (following recrystallization) [p-IC6H4SiO(1.5)]8, or I8OPS, in good yields and with excellent selectivity: >99% mono-iodo substitution with >93% para substitution as determined by H2O2/F- cleavage of the Si-C bonds to produce iodophenols. I8OPS in turn can be functionalized using conventional catalytic coupling reactions to provide sets of >93% para-substituted, functionalized compounds (alkynes, alkenes, aryl amines, phosphonates, aryl amines, polyaromatics, etc.), suggesting the potential to develop diverse nano-building blocks for the assembly of a wide variety of materials, some with novel photonic, electronic, and structural properties.

Polyphenylsilsesquioxane [PhSiO(1.5)](n) (PPS) and polyvinylsilsesquioxane [vinylSiO(1.5)](n) (PVS) are polymeric byproducts of the syntheses of the related T(8) octamers [PhSiO(1.5)](8) and [vinylSiO(1.5)](8). Here we demonstrate that random-structured PPS and PVS rearrange in the presence of catalytic amounts of Bu(4)N(+)F(-) in THF to form mixed-functionality polyhedral T(10) and T(12) silsesquioxane (SQ) cages in 80-90% yields. Through control of the initial ratio of starting materials, we can statistically tailor the average values for x for the vinyl(x)Ph(10-x)T(10) and vinyl(x)Ph(12-x)T(12) products. Metathetical coupling of x approximately = 2 vinyl cages with 4-bromostyrene produces SQs with an average of two 4-bromostyrenyl substituents. These products can be reacted via Heck coupling with vinylSi(OEt)(3) to produce SQs with vinylSi(OEt)(3) end-caps. Alternately, Heck coupling with the originally produced x approximately = 2 vinyl SQs leads to "beads on a chain" SQ oligomers joined by conjugated organic tethers. The functionalized T(10) and T(12) cages, metathesis, and Heck compounds were characterized by standard analytical methods (MALDI-TOF MS, (1)H and (13)C NMR spectroscopy, TGA, and GPC). MALDI confirms the elaboration of the cages after each synthetic step, and GPC verifies the presence of higher molecular weight SQ oligomers. TGA shows that all of these compounds are thermally stable in air (>300 degrees C). The UV-vis absorption and emission behavior of the Heck oligomers reveals exceptional red-shifts (> or = 60 nm) compared to the vinylSi(OEt)(3) end-capped model compounds, suggesting electronic interactions through the SQ silica cores. Such phenomena may imply 3-D conjugation through the cores themselves.

Poly(bromooctaphenylsilsesquioxane)s (Br x OPS) are easily synthesized from octaphenylsilsesquioxane (OPS) via bromination with Br2/Fe in dichloromethane. For Br:OPS ratios less than 8:1, singly brominated products are obtained with 65−70% para substitution, 25−20% meta substitution and the remainder ortho. Higher ratios provide dibrominated products up to Br16OPS. Surprisingly, the disubstitution pattern is completely different with 80% 2,5 substitution (meta and ortho to Si), indicating extensive rearrangement with addition of the second bromine. Br x OPS bromo functionality is readily transformed via low temperature catalytic coupling reactions with para-substituted styrenes, tetraphenylborate, methyl methacrylate, or toluidine into the corresponding fully substituted p-stilbenes, p-biphenyls, methyl cinnamates, and diarylamines. The p-stilbenes offer unusually large red shifts and order of magnitude increases on photoluminescence quantum efficiencies over stilbene itself. Methyl methacrylate addition provides a mechanism for forming cross-linkable films and can be used in conjunction with the other functionalization reactions. Reactions with phenylacetylenes occur with concomitant formation of vinyl bromides, which appear to react further, adding second acetylene groups. The fact that each phenyl group occupies a different octant in Cartesian space, for Br≤ 8OPS primarily para, offers the opportunity to create novel eight branched, highly conjugated cores of value in their own right but also of value as three-dimensional, eight or 16 branched, aromatic cores for the synthesis of dendrimer-like and/or hyperbranched molecules.

Cubic octameric silsesquioxanes, because of their octahedral structures and nanometer size, represent potentially very useful nanoconstruction sites. Here we report the reaction of octaaminophenylsilsesquioxane (OAPS) with a variety of epoxides and dianhydrides and their subsequent heat treatment to form nanocomposite films with exceptional oxygen barrier properties. While solution-cast films give relatively low oxygen transmission rates (OTR), casting followed by warm-pressing lowers the OTR to values competitive with commercially available high-performance barrier films. The lowest OTR measured was obtained with a warm-pressed bilayer films consisting of OAPS/tetraglycidyl-m-xylenediamine and OAPS/2,4-epoxycyclohexylmethyl-3,4-epoxycyclohexanecarboxylate with OTRs < 1 cm3 20 μm/(m2 day atm). These silsesquioxane films are thermally very robust, particularly the OAPS/imide films (>500 °C when fully cured), making them ideal for electronics packaging and encapsulation applications.

Silicone resins are traditional thermoset polymers with an inorganic backbone, affording chemical inertness and high thermal stability, which also makes them inherently difficult to recycle by traditional methods. Here, we demonstrate that catalytic amounts of fluoride ion at room temperature solubilize highly cross-linked silicone resins initially cured up to 250 °C. After solubilization equilibria are achieved, solvent is removed to reform the polymer network. Coatings on aluminum substrates and monoliths of virgin and recycled silicone resins were evaluated for hydrophobicity, wear resistance, substrate adhesion, and thermal stability. Silicones recycled under optimized conditions retained nearly 100% wear resistance, thermal stability, and adhesion properties. In some instances, the recycled coatings offer properties superior to the initial materials.

No abstract