This work identifies a benchmark for the performance of a small-scale ammonia synthesis plant powered by wind energy. The energy used is stranded, far from urban centers but near locations of fertilizer demand. The wind energy drives the pressure swing absorption of air to make nitrogen and the electrolysis of water to make hydrogen. These are combined in the small-scale continuous Haber process to synthesize ammonia. The analysis of runs of the small plant presented in this article permits an assessment of how the current production rate is controlled by three resistances: catalytic reaction, ammonia separation by condensation, and recycling of unreacted gas. The measured catalytic reaction rates are consistent with separate experiments on chemical kinetics and with published reaction mechanisms. The condensation rates predicted are comparable with literature correlations. These rate constants now supply a rigorous strategy for optimizing this scaled-down, distributed ammonia plant. Moreover, this method of analysis is recommended for future small-scale, distributed manufacturing plants.

Renewable wind energy can be used to make ammonia. However, wind-generated ammonia costs about twice that made from a traditional fossil-fuel driven process. To reduce the production cost, we replace the conventional ammonia condensation with a selective absorber containing metal halides, e.g., calcium chloride, operating at near synthesis temperatures. With this reaction-absorption process, ammonia can be synthesized at 20 bar from air, water, and wind-generated electricity, with rates comparable to the conventional process running at 150−300 bar. In our reaction-absorption process, the rate of ammonia synthesis is now controlled not by the chemical reaction but largely by the pump used to recycle the unreacted gases. The results suggest an alternative route to distributed ammonia manufacture which can locally supply nitrogen fertilizer and also a method to capture stranded wind energy as a carbon-neutral liquid fuel.

No abstract

A B S T R A C TIn the United States, commercial-scale cellulosic-ethanol production using corn (Zea mays L.) stover has become a reality. As the industry matures and demand for stover increases, it is important to determine the amount of biomass that can be sustainably harvested while safe-guarding soil quality and productivity. Specific study objectives were to measure indices of soil hydrological and aggregate stability responses to harvesting stover; since stover harvest may negatively impact soil hydrological and physical properties. Responses may differ with tillage management; thus, this paper reports on two independent studies on a tilled (Chisel field) and untilled field (NT1995 field). Each field was managed in a corn/soybean (Glycine max [Merr.]) rotation and with two rates of stover return: (1) all returned (Full Return Rate) and (2) an aggressive residue harvest leaving little stover behind (Low Return Rate). Unconfined field soil hydraulic properties and soil aggregate properties were determined. Hydrological response to residue treatments in the Chisel field resulted in low water infiltration for both rates of residue removal. In NT1995 field, Full Return Rate had greater capacity to transmit water via conductive pathways, which were compromised in Low Return Rate. Collectively, indices of soil aggregation in both experiments provided evidence that the aggregates were less stable, resulting in a shift toward more small aggregates at the expense of larger aggregates when stover is not returned to the soil. In both fields, aggressive stover harvest degraded soil physical and hydrological properties. No tillage management did not protect soil in absence of adequate residue.2016 Published by Elsevier B.V.

The combined use of solar photovoltaics and agriculture may provide farmers with an alternative source of income and reduce heat stress in dairy cows. The objective of this study was to determine the effects on grazing cattle under shade from a solar photovoltaic system. The study was conducted at the University of Minnesota West Central Research and Outreach Center in Morris, Minnesota on a grazing dairy. Twenty-four crossbred cows were randomly assigned to 2 treatment groups (shade or no shade) from June to September in 2019. The replicated (n = 4) treatment groups of 6 cows each were provided shade from a 30-kW photovoltaic system. Two groups of cows had access to shade in paddocks, and 2 groups of cows had no shade in paddocks. All cows were located in the same pasture during summer. Behavior observations and milk production were evaluated for cows during 4 periods of summer. Boluses and an eartag sensor monitored internal body temperature, activity, and rumination on all cows, respectively. Independent variables were the fixed effects of breed, treatment group, coat color, period, and parity, and random effects were replicate group, date, and cow. No differences in fly prevalence, milk production, fat and protein production, or drinking bouts were observed between the treatment groups. Shade cows had more ear flicks (11.4 ear flicks/30 s) than no-shade cows (8.6 ear flicks/30 s) and had dirtier bellies and lower legs (2.2 and 3.2, respectively) than no-shade cows (1.9 and 2.9, respectively). During afternoon hours, shade cows had lower respiration rates (66.4 breaths/min) than no-shade cows (78.3 breaths/min). From 1200 to 1800 h and 1800 to 0000 h, shade cows had lower body temperature (39.0 and 39.2°C, respectively) than no-shade cows (39.3 and 39.4°C, respectively). Furthermore, between milking times (0800 and 1600 h), the shade cows had lower body temperature (38.9°C) than no-shade cows (39.1°C). Agrivoltaics incorporated into pasture dairy systems may reduce the intensity of heats stress in dairy cows and increase well-being of cows and the efficiency of land use.