No abstract

No abstract

An end-to-end development approach for space flight qualified additive manufacturing (AM) components is presented and demonstrated with a case study consisting of a system of five large, light-weight, topologically optimized components that serve as an engine mount in SpaceIL's GLPX lunar landing craft that will participate in the Google Lunar XPrize challenge. The development approach includes a preliminary design exploration intended to save numerical effort in order to allow efficient adoption of topology optimization and additive manufacturing in industry. The approach also addresses additive manufacturing constraints, which are not included in the topology optimization algorithm, such as build orientation, overhangs, and the minimization of support structures in the design phase. Additive manufacturing is carried out on the topologically optimized designs with powder bed laser technology and rigorous testing, verification, and validation exercises complete the development process.

Three case studies utilizing topology optimization and Additive Manufacturing for the development of space flight hardware are described. The Additive Manufacturing (AM) modality that was used in this work is powder bed laser based fusion. The case studies correspond to the redesign and manufacture of two heritage parts for a Surrey Satellite Technology LTD (SSTL) Technology Demonstrator Space Mission that are currently functioning in orbit (case studies 1 and 2), and a system of five components for the SpaceIL’s lunar launch vehicle planned for launch in the near future (case study 3). In each case, the nominal or heritage part has undergone topology optimization, incorporating the AM manufacturing constraints that include: minimization of support structures, ability to remove unsintered powder, and minimization of heat transfer jumps that will cause artifact warpage. To this end the topology optimization exercise must be coupled to the Additive Manufacturing build direction, and steps are incorporated to integrate the AM constraints. After design verification by successfully passing a Finite Element Analysis routine, the components have been fabricated and the AM artifacts and in-process testing coupons have undergone verification and qualification testing in order to deliver structural components that are suitable for their respective missions.

No abstract

Structural characterization in polymer nanocomposites is usually performed using X-ray scattering and microscopic techniques, whereas the improvements in processing and mechanical properties are commonly investigated by rotational rheometry and tensile testing. However, all of these techniques are time consuming and require quite expensive scientific equipment. It has been shown that a fast and efficient way of estimating the level of reinforcement in polymer nanocomposites can be performed by melt extensional rheology, because it is possible to correlate the level of melt strength with mechanical properties, which reflect both the 3D network formed by the clay platelets/polymer chains as well as final molecular structure in the filled system. The physical network made of silicate filler and polymer matrix has been evaluated by X-ray diffraction and transmission electron microscopy. Extensional rheometry and tensile testing have been used to measure efficiency of the compatibilizer amount in a polypropylene-nanoclay system.

A melt pump was assembled into the compounding line to ensure both sufficient time for diffusion process of polymer chains into the silicate gallery and sufficient mechanical shear energy for exfoliation of clay layers. The melt pump in front of the open co-rotating twin-screw extruder controls the throughput rate and the residence time, whereas the screw speed and screw geometry in the extruder determine the mechanical shear energy applied on the compound. Due to melt pump employment, the melt in metering zone can be accumulated, which results in higher mixing efficiency. It was found that using the melt pump leads to up to two times higher residence time and, consequently, higher level of material reinforcement as investigated by extensional rheology. Different melt pump adjustments, screw geometries, and screw speeds were tested and their effect on processing characteristics and material reinforcement was investigated.

No abstract