Copper particles were incorporated into nanofibers during the electrospinning of poly-D,L-lactide (PDLLA) and poly(ethylene oxide) (PEO). The ability of the nanofibers to prevent Pseudomonas aeruginosa PA01 and Staphylococcus aureus (strain Xen 30) to form biofilms was tested. Nanofibers containing copper particles (Cu-F) were thinner (326 ± 149 nm in diameter), compared to nanofibers without copper (CF; 445 ± 93 nm in diameter). The crystalline structure of the copper particles in Cu-F was confirmed by X-ray diffraction (XRD). Copper crystals were encapsulated, but also attached to the surface of Cu-F, as shown scanning transmission electron microscopy (STEM) and transmission electron microscopy (TEM), respectively. The copper particles had no effect on the thermal degradation and thermal behaviour of Cu-F, as shown by thermogravimetric analysis (TGA) and differential scanning calorimeter (DSC). After 48 h in the presence of Cu-F, biofilm formation by P. aeruginosa PA01 and S. aureus Xen 30 was reduced by 41% and 50%, respectively. Reduction in biofilm formation was ascribed to copper released from the nanofibers. Copper-containing nanofibers may be incorporated into wound dressings.

Pseudomonas aeruginosa and Staphylococcus aureus are commonly associated with hospital-acquired infections and are known to form biofilms. Ciprofloxacin (CIP), which is normally used to treat these infections, is seldom effective in killing cells in a biofilm. This is mostly due to slow or weak penetration of CIP to the core of biofilms. The problem is accentuated by the release of CIP below MIC (minimal inhibitory concentration) levels following a rapid (burst) release. The aim of this study was to develop a drug carrier that would keep CIP above MIC levels for an extended period. Ciprofloxacin was suspended into poly(D,L-lactide) (PDLLA) and poly(ethylene oxide) (PEO), and electrospun into nanofibers (CIP-F). All of the CIP was released from the nanofibers within 2 h, which is typical of a burst release. However, 99% of P. aeruginosa PA01 cells and 91% of S. aureus Xen 30 cells (a methicillin-resistant strain) in biofilms were killed when exposed to CIP-F. CIP levels remained above MIC for 5 days, as shown by growth inhibition of the cells in vitro. The nanofibers were smooth in texture with no bead formation, as revealed by scanning electron and atomic force microscopy. A single vibration peak at 1632 cm-1, recorded with Fourier transform infrared spectroscopy, indicated that CIP remained in crystal form when incorporated into PDLLA: PEO. No abnormalities in the histology of MCF-12A breast epithelial cells were observed when exposed to CIP-F. This is the first report of the inhibition of biofilm formation by CIP released from PDLLA: PEO nanofibers.

Two α-amylase-producing strains of Lactobacillus plantarum were isolated from South African barley. The extracellular α-amylase activity produced by strain A.S1.2 coincided with cell growth, while strain B.S1.6 produced α-amylase mainly during stationary growth. Cell wall α-amylases in both strains were approximately five times higher than recorded for extracellular α-amylases. Both strains demonstrated highest extracellular α-amylase activity in 2% (w/v) maltose, followed by 2% (w/v) malt extract and 2% (w/v) starch, respectively. The α-amylase produced by the two strains functioned optimally at 50°C and under alkaline conditions. The two strains of L. plantarum fermented carbohydrates naturally present in barley, and produced cell-bound and cell-free α-amylase at alkaline conditions. The two strains may be developed into starter cultures to facilitate the germination of barley and produce malt with a higher fermentable sugar content.

No abstract