No abstract

No abstract

Two species of the genus Coffea, Coffea arabica (Colombia) and Coffea canephora (Indiano Robusta) were analysed by two-dimensional (2-D) maps in order to obtain fingerprints of the expressed polypeptide chains and to determine which ones would characterize the two species. Green beans were milled under liquid nitrogen. A dry powder was produced by three different extraction protocols aimed at eliminating interfering substances (polyphenols). A reduced powder was produced by two successive extractions performed in acetone. Trichloroacetic acid (TCA; 10% w/v) and beta-mercaptoethanol (0.07% v/v) in acetone were used for the first extraction (a) and 10% w/v TCA in acetone was used for the second extraction (b). Proteins were then solubilized in a solution (40 microL per 1 mg powder) containing 7 M urea, 2 M thiourea, 3% w/v 3-(3-cholamidopropyldimethyl-amino)-1-propanesulfate, 1% v/v carrier ampholytes, 40 mM Tris, 5 mM tributylphosphine and 10 mM acrylamide as alkylating agent. Following incubation at room temperature for 1 hour and centrifugation (7000 rpm for 20 minutes), the supernatant was used for 2-D electrophoresis. The proteins were revealed by Sypro Ruby staining. Master maps of the five replicas of each species were compared by PDQuest analysis. The results of this differential proteome analysis were: sixteen proteins were expressed solely in C. canephora (var. Indiano Robusta) and five proteins were only found in C. arabica (var. Colombia). Another eight proteins were up-regulated in C. canephora (var. Indiano Robusta) in comparison to C. arabica (var. Colombia) and one was down-regulated in the same comparison. A number of these polypeptide chains were further characterized by mass spectrometry in the matrix-assisted laser desorption/ionisation-time of flight mode. Additionally, considering the low number of protein sequences of Coffea present in the databases we also investigated some spots with a more powerful tool, reversed phase-high-performance liquid chromatography-electrospray ionisation-tandem mass spectrometry, thus obtaining an internal peptide sequence. The general properties of the identified proteins are presented and discussed.

Three A3B porphyrins with mixed carboxy-, phenoxy-, pyridyl-, and dimethoxy-substituent functionalization on the meso-phenyl groups were obtained by multicomponent synthesis, fully characterized and used as ionophores for preparing PVC-based membrane sensors selective to iron(III). The membranes have an ionophore:PVC:plasticizer composition ratio of 1:33:66. Sodium tetraphenylborate was used as additive (20 mol% relative to ionophore). The performance characteristics (linear concentration range, slope and selectivity) of the sensors were investigated. The best results were obtained for the membrane based on 5-(4-carboxyphenyl)-10,15,20-tris(4-phenoxyphenyl)-porphyrin plasticized with bis(2-ethylhexyl)sebacate, in a linear range from 1 × 10−7–1 × 10−1 M with a slope of 21.6 mV/decade. The electrode showed high selectivity with respect to alkaline and heavy metal ions and a response time of 20 s. The influence of pH on the sensor response was studied. The sensor was used for a period of six weeks and the utility has been tested for the quantitative determination of Fe(III) in recovered solutions from spent lithium ion batteries and for the quantitative determination of Fe(III) in tap water samples.

A micellar liquid chromatographic (MLC) procedure was developed for the clinical monitoring of imipramine and its active metabolite, desipramine. The determination of these highly hydrophobic substances was carried out after direct injection of the serum samples using a mobile phase composed of 0.15 m SDS--6% (v/v) pentanol buffered at pH 7, pumped at 1.5 mL/min into a C(18) column (250 x 4.6 mm), and electrochemical detection at 650 mV. Using this MLC method, calibration was linear (r > 0.995) and the limits of detection (ng/mL) were 0.34 and 0.24 for imipramine and desipramine, respectively. Repeatabilities and intermediate precision were tested at three different concentrations in the calibration range and a CV (%) below 2.2 was obtained. In this MLC procedure, the serum is determined without treatment, thus allowing repeated serial injections without changes in retention factors, and reducing the time and consumables required to carry out the pretreatment process. The assay method can be applied to the routine determination of serum imipramine and its metabolite in therapeutic drug monitoring.