Abstract-In this paper, we present a new method to determine the simultaneous injection and temperature dependence of the sum of the majority and minority carrier mobilities in silicon wafers. The technique is based on combining transient and quasi-steadystate photoconductance measurements. It does not require a full device structure or contacting but only adequate surface passivation. The mobility dependence on both carrier injection level and temperature, as measured on several test samples, is discussed and compared with well-known mobility models. The potential of this method to measure the impact of dopant concentration, compensation ratio, injection level, and temperature on the mobility is demonstrated.
The carrier mobility is a key parameter in determining the performance of silicon solar cells. The carrier mobility decreases with both injection level and temperature. Since solar cells often operate under a wide range of injection levels and temperatures, it is thus fundamental to determine the impact of those parameters on the carrier mobility. Numerous techniques exist to measure mobility, and the impact of dopant concentration and temperature is thus well known in crystalline silicon. Nevertheless, data on the impact of injection or the simultaneous impact of injection and temperature on the carrier mobility are scarce. Furthermore, the effect of dopant compensation on carrier mobilities, especially for minority carriers, remains unclear. Dannhauser and Krausse used a combination of infrared radiation and voltage measurements across a pin diode to extract the injection dependence of the mobility sum. Similarly, Neuhaus et al. used a combination of Quasi-steady-state photoconductance (QSS-PC) and Quasi-steady-state opencircuit-voltage (QSS-Voc) measurements on a solar cell to determine the injection dependence of the mobility sum. However, both of these methods require a complicated structure and need contacting. This can make it more difficult to perform temperature dependent measurements. In this paper we present a new method to determine the simultaneous injection and temperature dependence of the sum of the majority and minority carrier mobilities. Contrary to the method proposed by Neuhaus et al., this method doesn't require a full cell structure, only surface passivation. The mobility sum is determined by combined measurement of transient and Quasisteady-state photoconductance measurements. The mobility dependence on both injection and temperature is discussed and compared to several models. The potential of this method to measure the impact of dopant concentration, compensation ratio, injection level and temperature on the mobility is demonstrated.The above text is an abstract of a manuscript initially published in the IEEE Journal of Photovoltaics.View the full manuscript at
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.
hi@scite.ai
10624 S. Eastern Ave., Ste. A-614
Henderson, NV 89052, USA
Copyright © 2024 scite LLC. All rights reserved.
Made with 💙 for researchers
Part of the Research Solutions Family.