No abstract

No abstract

Microplastics in the environment are a subject of intense research as they pose a potential threat to marine organisms. Plastic fibers from textiles have been indicated as a major source of this type of contaminant, entering the oceans via wastewater and diverse non-point sources. Their presence is also documented in terrestrial samples. In this study, the amount of microfibers shedding from synthetic textiles was measured for three materials (acrylic, nylon, polyester), knit using different gauges and techniques. All textiles were found to shed, but polyester fleece fabrics shed the greatest amounts, averaging 7360 fibers/m−2/L−1 in one wash, compared with polyester fabrics which shed 87 fibers/m−2/L−1. We found that loose textile constructions shed more, as did worn fabrics, and high twist yarns are to be preferred for shed reduction. Since fiber from clothing is a potentially important source of microplastics, we suggest that smarter textile construction, prewashing and vacuum exhaustion at production sites, and use of more efficient filters in household washing machines could help mitigate this problem.

Engineering materials that can store electrical energy in structural load paths can revolutionize lightweight design across transport modes. Stiff and strong batteries that use solid‐state electrolytes and resilient electrodes and separators are generally lacking. Herein, a structural battery composite with unprecedented multifunctional performance is demonstrated, featuring an energy density of 24 Wh kg−1 and an elastic modulus of 25 GPa and tensile strength exceeding 300 MPa. The structural battery is made from multifunctional constituents, where reinforcing carbon fibers (CFs) act as electrode and current collector. A structural electrolyte is used for load transfer and ion transport and a glass fiber fabric separates the CF electrode from an aluminum foil‐supported lithium–iron–phosphate positive electrode. Equipped with these materials, lighter electrical cars, aircraft, and consumer goods can be pursued.

No abstract

A note on versions:The version presented here may differ from the published version or from the version of record. If you wish to cite this item you are advised to consult the publisher's version. Please see the repository url above for details on accessing the published version and note that access may require a subscription. We present new acrylic monomers derived directly from abundant naturally available terpenes via a facile, green and catalytic approach. These monomers can be polymerised to create new polymers with a wide range of mechanical properties that positions them ideally for application across the commodity and specialty plastics landscape; from packaging, cosmetic and medical, through to composites and coatings.We demonstrate their utility through formation of novel renewable polymer coatings.

Novel thermo-responsive cellulose (filter paper) surfaces of N-isopropylacrylamide (NIPAAm) and pH-responsive cellulose surfaces of 4-vinylpyridine (4VP) have been achieved via surface-initiated ATRP. Dual-responsive (pH and temperature) cellulose surfaces were also obtained through the synthesis of block-copolymer brushes of PNIPAAm and P4VP. With changes in pH and temperature, these "intelligent" surfaces showed a reversible response to both individual triggers, as indicated by the changes in wettability from highly hydrophilic to highly hydrophobic observed by water contact angle measurements. Adjusting the composition of the grafted blockcopolymer brushes allowed for further tuning of the wettability of these "intelligent" cellulose surfaces.

A model two‐step synthesis of a saturated hyperbranched hydroxyl‐terminated ester has been developed to show a synthesis route. Three different series of hyperbranched esters with different terminations have been synthesized to relate some of their properties to their structures. This route has then been used to synthesize three different allyl ethermaleate functional hyperbranched ester resins in a two‐step procedure. The resins have been characterized with respect to rheology, structure, and properties, and the differences are discussed. The allyl ether‐maleate functional resins have also been studied with respect to curing performance and final film properties. © 1993 John Wiley & Sons, Inc.