No abstract

Autonomous Surface Vessels (ASVs) are reliable and robust vehicles. They perform autonomous missions in lakes, rivers and even open waters. Those are dangerous environments that requires precise and secure navigation. Under these conditions, the knowledge of a robust and accurate mathematical model is a fundamental aspect for adjusting the control system for reaching safety and performance. Moreover, traditional mathematical models disregard assimetries and coupling between the degrees of freedom. While those models work fine for bigger vessels, to ignore these characteristics in small ASVs compromises the model's quality. In this context, this work presents a new methodology for modeling and identifying the dynamics of ASVs along with the uncertainties arising from disturbances and non-modeled dynamics. As for the uncertainties and disturbances, this work considers the coupling parameters into the mathematical modeling, which synthesizes the divergences between the model and the real application, allowing to incorporate asymmetries and model deficiencies. Regarding the parameter identification, the proposal is based on (i) the design of optimal input excitation signals from a double layer optimization methodology and (ii) a parametric estimation concept in two steps, dividing the original set of parameters into two partially coupled sub-problems. Finally, this work also presents a full discussion and analysis about the importance to manage the trade-off between precision and complexity of mathematical models, its respective solution spaces and the impact over the optimization algorithms. To validate the approach, a real 3 Degree of Freedom ASV with aerial holonomic propulsion system is used. The results show that it is possible to successfully capture the complex set of parameters and identify physical characteristics not considered by the model.

No abstract

Acoustic Doppler Current Profiler (ADCP) sensors measure water inflows and are essential to evaluate the Flow Curve (FC) of rivers. The FC is used to calibrate hydrological models responsible for planning the electrical dispatch of all power plants in several countries. Therefore, errors in those measures propagate to the final energy cost evaluation. One problem regarding this sensor is its positioning on the vessel. If placed on the bow, it becomes exposed to flowing obstacles, and if it is installed on the stern, the redirected water from the boat and its propulsion system change the sensor readings. To improve the sensor readings, this paper proposes the design of a catamaran-like Autonomous Surface Vessel (ASV) with an optimized hull design, aerial propulsion, and optimal sensor placement to keep them protected and precise, allowing inspections in critical areas such as ultra-shallow waters and mangroves.

It is well known that activities in running water or wind and waves expose the Autonomous Surface Vessels (ASVs) to considerable challenges. Under these conditions, it is essential to develop a robust control system that can meet the requirements and ensure the safe and accurate execution of missions. In this context, this paper presents a new topology for controller design based on a combination of the Successive Loop Closure (SLC) method and optimal control. This topology enables the design of robust autopilots based on the Proportional-Integral-Derivative (PID) controller. The controllers are tuned from the solution of the optimal control problem, which aims to minimize the effects of model uncertainties. To verify the effectiveness of the proposed controller, a numerical case study of a natural ASV with 3 Degree of Freedom (DoF) is investigated. The results show that the methodology enabled the tuning of a PID controller capable of dealing with different parametric uncertainties, demonstrating robustness and applicability for different prototype scenarios.INDEX TERMS Robust control design, successive loop closure, optimal control, PID controller, autonomous surface vehicles.