Resonance-enhanced multiphoton ionization time-of-flight mass spectrometry (REMPI-TOFMS) was used to study the characteristic signal behaviors obtained from two types of emulsions: water-in-oil (W/O) and oil-in-water (O/W). All emulsions were prepared using phase inversion emulsification, i.e., a solution for an aqueous phase was added dropwise to an oil phase with constant stirring to obtain an emulsion. Toluene served as a detection component. When using REMPI-TOFMS to measure an emulsion, a time profile for the target component can be constructed by plotting peak areas for the corresponding component on a series of mass spectra. In the case of a W/O emulsion at a water volume fraction (f w) of 0.005, the concentration of toluene was instantaneously decreased due to the existence of water droplets, and therefore, several negative spikes were detected on the time profile while establishing a baseline. In the case of a W/O emulsion at f w = 0.3, negative peaks consisting of several plots appeared on the time profile because of the formation of aggregates of water droplets while the emulsion was flowed through a capillary column for sample introduction. An O/W emulsion at f w = 0.995 was analyzed following phase inversion, and positive peaks were detected due to the aggregates of many oil droplets. In this manner, the direct mass analysis of emulsions before and after phase inversion was achieved, and the resultant signal inversion was confirmed via REMPI-TOFMS.

This study used resonance-enhanced multiphoton ionization time-of-flight mass spectrometry (REMPI-TOFMS) to evaluate the phase inversion that is driven via temperature change. A change in temperature prompts phase inversion in an oil-in-water (O/W) emulsion that uses a nonionic surfactant as an emulsifier. In this study, an O/W emulsion was prepared containing Triton X-100 as an emulsifier. To promote emulsion inversion, we heated only the outlet of a capillary column that was used for sample introduction during REMPI-TOFMS. When the emulsion was continuously measured at 40 C, several intense spikes could be detected on a time profile for the analyte, toluene, constructed by extracting the peak areas from a series of obtained mass spectra. This indicated the presence of toluene droplets in the O/W emulsion. No intense spikes appeared at 80 C, however, which suggested the shrinkage or even disappearance of the oil droplets following phase inversion. Using this technique, an emulsion can be measured without affecting the influence of vaporization even at elevated temperatures, which surely is a serious concern when using other analytical techniques. Therefore, this technique would be quite useful for evaluating the phase inversion of an emulsion at elevated temperatures.

In this study, we used a quantitative analytical method to indicate creaming behavior in an emulsion. An oil-in-water emulsion was directly measured by resonance-enhanced multiphoton ionization time-of-flight mass spectrometry, and the time profiles of the peak areas of an oil component, styrene, were obtained at heights of 1, 2, and 3 cm from the bottom of a sample that had a height of 4 cm. All time profiles roughly indicated that the signal intensity increased once, then decreased, and finally settled. Moreover, we proposed a fitting equation for the time profiles by subtracting two sigmoid functions, whereby the degree of the signal increases at the initial stage, the degree of the signal decreases after the increase, and the times for continuing the higher signal intensities were all longer as the monitoring positions were raised. This method would surely provide useful information about emulsions that undergo creaming behavior.

No abstract