AlCrN/TiSi, AlCrN/TiCrSiN and AlCrN/AlCrN + CrN coatings were deposited on Inconel 718 alloy by physical vapour deposition (PVD). The corrosion behaviour of uncoated and coated specimens was evaluated using electrochemical impedance spectroscopy (EIS) at open circuit potential in a 3.5 wt.% NaCl and 2 wt.% H2SO4 solutions. The EIS data acquired were curve fitted and analysed by equivalent circuit models to calculate the pore resistance, the charge transfer resistance and the capacitance. The Nyquist diagrams of all systems showed one part of the semicircle which could relate that reaction is a one step process, except for the AlCrN/TiCrSiN and AlCrN/AlCrN + CrN coatings in H2SO4 solution, for which two semicircles related to active corrosion in substrate alloy were found. However, from the Bode plots, it was possible to identify two the time constants for all systems exposed to NaCl and H2SO4 solutions. According to electrochemical results, the corrosion resistance of the AlCrN/TiSiN coating was better in the NaCl solution, whereas the AlCrN/AlCrN + CrN coating show better performance in the Sulphuric Acid solutions.

Advanced high-strength steels (AHSS), are commonly used in the manufacture of car bodies, as well as in front and rear rails, and safety posts. These components can be exposed to corrosive environments for instance, in countries where de-icing salts are used. In this work, the corrosion behavior of four AHSS steels with dual-phase [ferrite-martensite (DP) and ferrite-bainite (FB)] steels were studied by means of electrochemical noise (EN) measurements according to the ASTM G199-09 standard in NaCl, CaCl2 and MgCl2 aqueous solutions at room temperature. The direct current (DC) trend data from EN were removed by a polynomial method of statistical and spectral analysis. According to the noise resistance (Rn) values obtained for the DP and FB dual-phase steels, both the martensite/bainite content and morphology of the phase constituents have an important effect on the corrosion behavior of these steels. The L.I. (localization index) (0.00054 to 0.15431), skewness (−6.18 to 7.35) and kurtosis (high values 37.15, 74.84 and 106.52) were calculated. In general, the results indicated that the main corrosion process is related to uniform corrosion. Corrosion behavior of AHSS steels exposed in NaCl solution could be related to the morphology of the phase constituents exposed in NaCl, CaCl2 and MgCl2 solutions.

No abstract

No abstract