No abstract

No abstract

Over the last few years, alloplastic bone substitute materials are raising much interest as an alternative to autologic transplants and xenogenic materials especially in oral surgery. These non-immunogenic and completely resorbable biomaterials are becoming the basis for complete and predictable guided bone regeneration in many cases. The objective of our research was to evaluate the dynamics of bone formation in rats' skulls after implantation of the new chitosan/tricalcium phosphate/alginate biomaterial in comparison to the commercially available alloplastic bone graft. A total of 45 adult male rats weighing 300-400 g were used for the study. The 85-mm-diameter defects in calvaria bone were prepared with a trephine bur, and then filled with the bone substitute materials: chitosan/tricalcium phosphate/alginate or easy-graft Classic (Degradable Solutions AG) (EA) or left just with the blood clot. Animals were sacrificed at 1 and 3 months for histological, histomorphometrical and micro-tomographic evaluations. Histological evaluation at 1 month showed early new bone formation, observed around the experimental biomaterial (CH/TCP/Alg). There were no features of purulent inflammation and necrosis or granulomatous inflammation. Microscopic examination after 3 months following the surgery revealed trabecular bone formation around chitosan-based bone graft with no significant inflammatory response. Less satisfactory and differing results were observed for the commercially available EA and control blood clot. The tested material (chitosan) showed a high degree of biocompatibility and osteoconductivity in comparison with the control groups. Additionally, it seemed to be a "user-friendly" material for oral surgeons.

In the hereby presented work the authors describe a technique of high-compression-resistant biodegradable bone scaffold preparation. The methodology is based on the agglomeration of chitosan (CH) and chitosan/β-tricalcium phosphate (CH/TCP) microspheres and represents a novel approach to 3D matrices design for bone tissue engineering application. The materials were prepared from high deacetylation degree chitosan. The authors describe the method for scaffold fabrication, essential properties of the materials manufactured and the influence of various TCP concentrations on material morphology, mechanical properties (for dry and hydrated materials) and preliminary study on the interaction between CH or CH/TCP scaffolds and within cultured MG-63 osteoblast-like cells. The properties of the obtained materials were significantly affected by the calcium phosphate content, which had a particular influence on the granule microstructure, size distribution and inner biomaterial pore size. The water uptake ability was found to be lower for the materials enriched with the inorganic phase and tended to decrease with the increasing calcium phosphate concentration. The evaluation of mechanical properties has revealed that scaffolds produced with the usage of granule-based technology display a potential to be used as a load-bearing material since the Young's modulus values were limited to the range of 200-500 MPa for dry materials and 15-20 MPa for the hydrated state of the scaffolds. The cell number, identified in three time points (48 h, 7 and 14 days) by Pico Green assay, was lower for the materials enriched with inorganic phase (75 % of control), however cell distribution, when compared to CH only biomaterial, was acknowledged as steadier on the surface of the material containing the highest calcium phosphate concentration.

Background. Alloplastic biomaterials are an alternative for autologous transplants and xenografts in oral surgery and dental implantology. These non-immunogenic and resorbable materials are becoming the basis for complete and predictable guided bone regeneration in many cases. The chemical composition of a great majority of them is based on calcium phosphate salts. In vivo performance is often variable. Objectives. The objective was to evaluate the biological and chemical properties of an experimental bone substitute material. Material and Methods. The present research focuses on the cytotoxicity comparison and physiochemical characterization of two biomaterials: a novel chitosan/tricalcium phosphate/alginate composite (CH/TCP/Ag) and a commercially available synthetic bone graft made of HA (60%) and βTCP (40%) (HA/TCP). The materials were evaluated according to PN-EN ISO 10993 Biological evaluation of medical devices i.e. cytotoxicity on mouse fibroblasts (L929) and, in addition, tests on human osteoblasts (hFOB1.19) and human osteosarcoma (MG-63) were conducted. The crystallochemical analysis was performed using the X-ray powder diffraction method. The Bruker--AXS D8 Advance diffractometer (Karlsruhe, Germany) was used to collect diffractograms. Results. The tested materials showed a close resemblance in chemical composition and a considerable differentiation in cytotoxic response. Conclusions.The novel composite demonstrated a high degree of cytocompatibility, which is promising in future clinical trials (Adv Clin Exp Med 2015, 24, 3, 511-516).

This study on tannery wastewater treatment showed that indirect electrooxidation by chlorine generated at a Ti/SnO/PdO/RuO (SPR) anode led to full ammonia removal, and a decrease in chemical oxygen demand (COD) of up to 77.0%. A combined process of coagulation + HO/UV + electrooxidation allowed us to achieve a decrease in COD of up to 97.5%. Equations describing the kinetics of the decrease in COD, the relationship between the decrease in COD and current, and the relationship between the current efficiency of COD reduction and the initial concentrations of the reagents were established. The changes in the Adsorbable Organically Bound Halogen (AOX) value were determined, and the individual compounds, including chloroorganics, present in raw and treated wastewater were identified by gas chromatography mass spectrometry (GC-MS). Values of AOX increased in the initial phase of electrooxidation, while afterwards they decreased.

No abstract

No abstract