Conventional polyalkylene glycols (PAGs) that are derived from the polymerization of ethylene oxide and/or propylene oxide provide many performance benefits such as excellent friction control, good low temperature properties, high viscosity indices and excellent deposit control. One limitation is their poor miscibility in hydrocarbon oils. A new range of oil‐soluble PAG base oils has been developed using butylene oxide as one of the precursors, and these provide superior miscibility in hydrocarbon base stocks. The new base oils offer many of the traditional advantages of PAGs such as high viscosity indices, good low temperature properties and good traction behaviour. In addition, they can be used as a co‐base oil or additive in hydrocarbon base stocks to improve deposit control and provide good film‐forming behaviour. Examples of their structure property relationships will be discussed and also aspects of how this technology may enable application expansion of PAGs in the future. Copyright © 2012 John Wiley & Sons, Ltd.

There is a significant amount of interest and research in seed-oil-derived lubricants because of elevated environmental consciousness among producers and consumers. While slowly making inroads into selected applications, performance deficits at low temperature and poor thermooxidative stability have consistently relegated seed oil derivatives to roles where biodegradability is paramount or where the performance requirements are relatively low. In this article, the structural attributes that result in seed-oil-derived lubricant properties are defined and quantified. Also, the seed oil triglyceride components are segregated, functionalized, and polymerized to provide a lubricant design that allows flexibility in defining the specified viscosity, while providing an improved low-temperature performance and removing the source of thermooxidative instability.

Synthetic lubricants are increasingly used to provide equipment reliability for wind turbine gear boxes. The majority of synthetic lubricants used today are based on polyalphaolefins. In gear systems where contact pressures are high, the pressure viscosity coefficient and traction values of the lubricant are important fundamental properties. A comparison of these properties for a wind turbine lubricant based on a polyalphaolefin and two lubricants based on polyalkylene glycols has been undertaken. Pressure viscosity coefficients were calculated from viscosity measurements made using an ultra‐high pressure falling needle viscometer at pressures up to 50 000 psi. Significant differences in properties were observed with both polyalkylene glycol lubricants showing lower pressure viscosity coefficients and much lower traction values. A calculation of the film thickness values in the Hertzian contact zone suggests that polyalkylene glycol lubricants may provide elastohydrodynamic films that are approximately 25% thicker than polyalphaolefin lubricants. Copyright © 2012 John Wiley & Sons, Ltd.

The title compound (VI) is prepared as shown.

No abstract