Here we have investigated the effect of enshrouding polymer-coated nanoparticles (NPs) with polyethylene glycol (PEG) on the adsorption of proteins and uptake by cultured cells. PEG was covalently linked to the polymer surface to the maximal grafting density achievable under our experimental conditions. Changes in the effective hydrodynamic radius of the NPs upon adsorption of human serum albumin (HSA) and fibrinogen (FIB) were measured in situ using fluorescence correlation spectroscopy. For NPs without a PEG shell, a thickness increase of around 3 nm, corresponding to HSA monolayer adsorption, was measured at high HSA concentration. Only 50% of this value was found for NPs with PEGylated surfaces. While the size increase clearly reveals formation of a protein corona also for PEGylated NPs, fluorescence lifetime measurements and quenching experiments suggest that the adsorbed HSA molecules are buried within the PEG shell. For FIB adsorption onto PEGylated NPs, even less change in NP diameter was observed. In vitro uptake of the NPs by 3T3 fibroblasts was reduced to around 10% upon PEGylation with PEG chains of 10 kDa. Thus, even though the PEG coatings did not completely prevent protein adsorption, the PEGylated NPs still displayed a pronounced reduction of cellular uptake with respect to bare NPs, which is to be expected if the adsorbed proteins are not exposed on the NP surface.

Synthesis, characterization, and applications of colloidal nanoparticles have been a prominent topic of current research interests within the last two decades. Available reports in the literature that describe the synthesis of colloidal nanoparticles are abundant with various degrees of reproducibility and simplicity. Moreover, different methods for the characterization of colloidal nanoparticles' basic properties are employed, resulting in conflicting results in many cases. Herein, we describe "in detail" selected standard protocols for the synthesis, purification, and characterization of various types of colloidal inorganic nanoparticles including gold nanoparticles, silver nanoparticles, iron oxide nanoparticles, and quantum dots. This report consists of five main parts: The first and the second part are dedicated to describing the synthesis of various types of hydrophobic and hydrophilic nanoparticles in organic solvents and in aqueous solutions, respectively. The third part describes surface modification of nanoparticles with focus on ligand exchange reactions, to allow phase transfer of nanoparticles from aqueous to organic solvents and vice versa. The fourth and the fifth part describe various general purification and characterization techniques used to purify and characterize nanoparticles, respectively. Collectively, this contribution does not aim to cover all available protocols in the literature to prepare inorganic nanoparticles, but rather provides detailed synthetic procedures to important inorganic nanocrystals with full description of their purification and characterization process.

A quartz crystal microbalance was integrated into an AFM in order to monitor the adsorption of biomolecules to the resonator surface with both atomic force microscopy and microgravimetry. The comparison between the two techniques allows the fractional coverage of the surface, theta, to be correlated with the frequency shift of the resonator, deltaf. The adsorbed material was ferritin, which is a spherical protein with a diameter of approximately 12 nm. Even ata coverage below 50%, the protein layer exhibits Sauerbrey-like behavior, meaning that the magnitude in the frequency shift [deltaf] much exceeds the shift in bandwidth and that the normalized frequency shift, deltaf/n (n the overtone order), is similar on the different overtones. The relation between coverage and frequency shift was found to be nonlinear. In order to model this situation, we performed finite element method calculations based on the incompressible Navier-Stokes equation. The comparison between the model and the experiment suggests that the deformation of the protein upon adsorption is small. For low coverage, the volume of the trapped solvent exceeds the volume of the adsorbate itself. The ratio of the two decreases with increasing coverage. This is the cause of the experimentally observed nonlinear relationship between the surface coverage and frequency shift. Comparing frequency shifts at different overtones, one finds that deltaf/n slightly decreases with overtone order. Such a behavior is typically attributed to softness. The model shows that, for the adsorbed spheres, this apparent softness arises through a rocking motion of the spheres at the surface instead of the shear deformation. Also, there is a hydrodynamic contribution (related to roughness) to the overtone dependence of deltaf/n.

Colloidal nanoparticles (NPs) are a versatile potential platform for in vivo nanomedicine. Inside blood circulation, NPs may undergo drastic changes, such as by formation of a protein corona. The in vivo corona cannot be completely emulated by the corona formed in blood. Thus, in situ detection in complex media, and ultimately in vivo, is required. Here we present a methodology for determining protein corona formation in complex media. NPs are labeled with 19F and their diffusion coefficient measured using 19F diffusion-ordered nuclear magnetic resonance (NMR) spectroscopy. 19F diffusion NMR measurements of hydrodynamic radii allow for in situ characterization of NPs in complex environments by quantification of protein adsorption to the surface of NPs, as determined by increase in hydrodynamic radius. The methodology is not optics based, and thus can be used in turbid environments, as in the presence of cells.

Deformation of surface-adsorbed liposomes is an important parameter that governs the kinetics of their transformations, but one that is very difficult to measure in the case of nm-size liposomes. We investigate the deformation of dimyristoyl phosphatidyl choline liposomes by quartz crystal microbalance (QCM) as a function of temperature and show that it follows the dependence of this lipid's bending modulus on temperature, as expected from theoretical considerations. To corroborate our approach, we model QCM response from adsorbed liposomes by explicitly considering their shape and mechanical properties.