Metals and ultraviolet (UV) radiation are two environmental stressors that can cause damage to plants. These two types of stressors often impact simultaneously on plants and both are known to promote reactive oxygen species (ROS) production. However, little information is available on the potential parallel stress responses elicited by metals and UV radiation. Using the aquatic plant Lemna gibba, we found that copper and simulated solar radiation (SSR, a light source containing photosynthetically active radiation (PAR) and UV radiation) induced similar responses in the plants. Both copper and SSR caused ROS formation. The ROS levels were higher when copper was combined with SSR than when applied with PAR. Higher concentrations of copper plus PAR caused toxicity as monitored by diminished growth and chlorophyll content. This toxicity was more pronounced when copper was combined with SSR. Because the generation of ROS was also higher when copper was combined with SSR, we attributed this enhanced toxicity to elevated levels of ROS. In comparison to PAR-grown plants, SSR treated plants exhibited elevated levels of superoxide dismutase (SOD) and glutathione reductase (GR). These enzyme levels were further elevated under both PAR and SSR when copper was added at concentrations that generated ROS. Interestingly, copper treatment in the absence of SSR (i.e. copper plus PAR) induced synthesis of the same flavonoids as those observed in SSR without copper. Finally, addition of either dimethyl thiourea or GSH (two common ROS scavengers) lowered in vivo ROS production, alleviated toxicity and diminished induction of GR as well as accumulation of UV absorbing compounds. Thus, the potential of ROS being a common signal for acclimation to stress by both copper and UV can be considered.

Tests with vertebrates are an integral part of environmental hazard identification and risk assessment of chemicals, plant protection products, pharmaceuticals, biocides, feed additives and effluents. These tests raise ethical and economic concerns and are considered as inappropriate for assessing all of the substances and effluents that require regulatory testing. Hence, there is a strong demand for replacement, reduction and refinement strategies and methods. However, until now alternative approaches have only rarely been used in regulatory settings. This review provides an overview on current regulations of chemicals and the requirements for animal tests in environmental hazard and risk assessment. It aims to highlight the potential areas for alternative approaches in environmental hazard identification and risk assessment. Perspectives and limitations of alternative approaches to animal tests using vertebrates in environmental toxicology, i.e. mainly fish and amphibians, are discussed. Free access to existing (proprietary) animal test data, availability of validated alternative methods and a practical implementation of conceptual approaches such as the Adverse Outcome Pathways and Integrated Testing Strategies were identified as major requirements towards the successful development and implementation of alternative approaches. Although this article focusses on European regulations, its considerations and conclusions are of global relevance.

Abstract-The need for alternative approaches to the use of vertebrate animals for hazard assessment of chemicals and pollutants has become of increasing importance. It is now the first consideration when initiating a vertebrate ecotoxicity test, to ensure that unnecessary use of vertebrate organisms is minimized wherever possible. For some regulatory purposes, the use of vertebrate organisms for environmental risk assessments has been banned; in other situations, the number of organisms tested has been dramatically reduced or the severity of the procedure refined. However, there is still a long way to go to achieve a complete replacement of vertebrate organisms to generate environmental hazard data. The development of animal alternatives is based not just on ethical considerations but also on reducing the cost of performing vertebrate ecotoxicity tests and in some cases on providing better information aimed at improving environmental risk assessments. The present Focus article provides an overview of the considerable advances that have been made toward alternative approaches for ecotoxicity assessments over the last few decades. Environ Toxicol Chem 2016;35:2637-2646. # 2016 SETAC

Polycyclic aromatic hydrocarbons and their derivatives are ubiquitous environmental contaminants. They are commonly present in complex mixtures with other contaminants, such as metals. The toxicities of phenanthrene (PHE) and 9,10-phenanthrenequinone (PHQ) with or without Cu were determined using Daphnia magna. Copper was the most toxic among the three chemicals tested, followed by PHQ and then PHE, with 48-h median effective concentrations (EC50s) of 0.96, 1.72, and 5.33 microM, respectively. Copper at 0.31 microM, or approximately the 5% effective concentration, decreased the EC50 of PHQ from 1.72 to 0.28 microM. Likewise, PHQ at 1.2 microM, or approximately the 10% effective concentration, significantly lowered the EC50 of Cu from 0.96 to 0.30 microM. This synergistic effect was not observed, however, in mixtures of Cu and PHE based on the response addition model. Assimilation of Cu wasfound to be similar with or without PHQ at increasing external concentrations of Cu, indicating that the increased toxicity of their mixtures is physiologically based. The ability of Cu plus PHQ to generate reactive oxygen species (ROS) was measured as well. Copper alone caused elevated ROS levels at a low concentration (0.63 microM). With PHQ present, however, this elevation in ROS occurred at an even lower Cu level (0.31 microM). Possible attenuation effects of ascorbic acid (vitamin C) on toxicity and ROS production induced by Cu, PHQ, and their mixtures were then examined. Ascorbic acid protected against Cu and Cu-plus-PHQ mixture-mediated toxicity but did not affect PHQ toxicity. Ascorbic acid also lowered ROS levels in the presence of Cu and Cu plus PHQ. We conclude that there exist potential toxic interactions between metals and modified PAHs and that these interactions can involve ROS formation.

Polycyclic aromatic hydrocarbons (PAHs) are ubiquitous environmental contaminants known for their photoinduced toxicity. This toxicity may occur through two mechanisms: Photosensitization, and photomodification. Photosensitization generally leads to the production of singlet oxygen, a reactive oxygen species that is highly damaging to biological molecules. Photomodification of PAHs, usually via oxidation, results in the formation of new compounds and can occur under environmentally relevant levels of actinic radiation. The toxicities of 16 intact PAHs to Daphnia magna were assessed under two ultraviolet radiation conditions. The toxicity of intact PAHs generally increased in the presence of full-spectrum simulated solar radiation relative to that in the presence of visible light plus ultraviolet A only. Despite the knowledge of a bipartite mechanism of phototoxicity that includes photosensitization and photomodification, few studies have examined the effects of PAH photoproducts on animals. To expand the existing data, 14 PAH photoproducts (oxy-PAHs) also were assayed, most of which were highly toxic without further photomodification. Two photoproducts of benzo[a]pyrene, 1,6- and 3,6-benzo[a]pyrenequinone, were the most toxic compounds tested, followed closely by benz[a]anthraquinone. Each of these three compounds had a median effective concentration in the low nanomolar range. The data presented highlight the effects of ultraviolet radiation on mediating PAH toxicity and the need to analyze absorption spectra of contaminants in the prediction of photoinduced toxicity. The importance of the role of photomodification also is stressed, because several oxy-PAHs, an unregulated group of contaminants, were highly toxic to D. magna, a key bioindicator species in aquatic ecosystems.

Emissions of plastic waste to the environment and the subsequent degradation into microplastic particles that have the potential to interact with biological organisms represent a concern for global society. Current understanding of the potential impacts on aquatic and terrestrial population stability and ecosystem structure and function associated with emissions of microplastic particles is limited and insufficient to fully assess environmental risks. Multistakeholder discussions can provide an important element in helping to identify and prioritize key knowledge gaps in assessing potential risks. In the present review, we summarize multistakeholder discussions from a 1‐d International Council of Chemical Associations–sponsored symposium, which involved 39 scientists from 8 countries with representatives from academia, industry, and government. Participants were asked to consider the following: discuss the scientific merits and limitations of applying a proposed conceptual environmental risk assessment (ERA) framework for microplastic particles and identify and prioritize major research needs in applying ERA tools for microplastic particles. Multistakeholder consensus was obtained with respect to the interpretation of the current state of the science related to effects and exposure to microplastic particles, which implies that it is unlikely that the presence of microplastic in the environment currently represents a risk. However, the quality and quantity of existing data require substantial improvement before conclusions regarding the potential risks and impacts of microplastic particles can be fully assessed. Research that directly addresses the development and application of methods that strengthen the quality of data should thus be given the highest priority. Activities aimed at supporting the development of and access to standardized reference material were identified as a key research need. Environ Toxicol Chem 2019;38:2087–2100. © 2019 The Authors. Environmental Toxicology and Chemistry published by Wiley Periodicals, Inc. on behalf of SETAC.

No abstract

This work presents the results of an international interlaboratory comparison on ex situ passive sampling in sediments. The main objectives were to map the state of the science in passively sampling sediments, identify sources of variability, provide recommendations and practical guidance for standardized passive sampling, and advance the use of passive sampling in regulatory decision making by increasing confidence in the use of the technique. The study was performed by a consortium of 11 laboratories and included experiments with 14 passive sampling formats on 3 sediments for 25 target chemicals (PAHs and PCBs). The resulting overall interlaboratory variability was large (a factor of ∼10), but standardization of methods halved this variability. The remaining variability was primarily due to factors not related to passive sampling itself, i.e., sediment heterogeneity and analytical chemistry. Excluding the latter source of variability, by performing all analyses in one laboratory, showed that passive sampling results can have a high precision and a very low intermethod variability (