Ziprasidone is known as a novel “atypical” or “second-generation” antipsychotic drug. A sensitive and reproducible method was developed and validated for determination of ziprasidone and its major impurities, which are significantly different in polarity. The separation is performed on a Waters Spherisorb® octadecylsilyl 1 column (5.0 μm particle size, 250 × 4.6 mm id) using a gradient with mobile phase A [buffer–acetonitrile (80 + 20, v/v)] and mobile phase B [buffer–acetonitrile (10 + 90, v/v)] at a working temperature of 25°C. The buffer was 0.05 M KH2PO4 solution with an addition of 10 mL triethylamine/L solution, adjusted to pH 2.5 with orthophosphoric acid. The flow rate was 1.5 mL/min, and the eluate was monitored at 250 nm using a diode array detector. Optimization of the experimental conditions was performed using partial least squares regression, for which four factors were selected for optimization: buffer concentration, buffer pH, triethylamine concentration, and temperature. The proposed validated method is convenient and reliable for the assay and purity control in both raw materials and dosage forms.
Multiresponse optimization methodology in combination with experimental design was employed as a powerful technique for simultaneous optimization of input variables significant for evaluation of chromatographic behaviour of zolpidem tartrate, zolpacid, oxozolpidem, zolpyridine and zolpaldehyde towards various responses. In the first stage of the investigation fractional factorial design was used to decrease the number of variables that should be studied in detail. Among examined variables, pH of the mobile phase, percentage of organic modifier and buffer concentration showed to be statistically important and were consequently optimized with central composite design and Derringer's desirability function. Four responses were considered, the retention factors of zolpacid and zolpaldehyde (the first and last peak) and the resolutions between critical peaks. Optimal conditions included Luna C 18 (2) analytical column (250 mm x 4.6 mm, 5 lm particle size), mobile phase consisted of methanol-10 mM ammonium acetate (68.4:31.6, v/v, pH 5.4) and column temperature of 35°C. The flow rate of the mobile phase was 1 mL min -1 and the detection was performed at 254 nm. At the end, the method was successfully validated in accordance with ICH guideline and subsequently applied to the analysis of commercially available zolpidem tartrate tablets.
Summary. The present study was designed to characterize the possible degradation products of zolpidem tartrate under various stress conditions according to International Conference on Harmonization (ICH) guidelines Q1A(R2). After exposure to light, heat, hydrolysis, and oxidation, the drug significantly degraded under photolytic and acid/base hydrolytic conditions. Degradation resulted in the formation of four key degradants. Degradation products were resolved from each other and the drug by employing an isocratic elution method on Luna C 18 column with mobile phase consisting of methanol-10 mM ammonium acetate (68.4:31.6, v/v), wherein pH was adjusted to 5.4 with glacial acetic acid. To characterize the degradation products, a method was extended to LC-MS and a mass fragmentation pattern was established using single quadrupole. The degradants were identified as zolpacid, oxozolpidem, zolpaldehyde, and zolpyridine. Finally, the most possible degradation mechanism of zolpidem tartrate in different environments was proposed.
Complete evaluation of chromatographic behavior and establishment of optimal experimental conditions for determination of torasemide and its four impurities are determined by experimental design. Fractional factorial and 3(n) full factorial design were employed for efficient and rapid optimization of liquid chromatography-ultraviolet and liquid chromatography-mass spectrometry (LC-MS) methods. Separation is achieved on a Zorbax SB C(18) analytical column (250 x 4.6 mm, 5 µm) with mobile phase consisting of acetonitrile and 10 mM ammonium formate (pH 2.5 with formic acid) in gradient mode. The flow rate is 1 mL min(-1), the temperature of the column is 25 °C and UV detection is performed at 290 nm. The efficiency of ionization in electrospray ionization is higher than in atmospheric pressure chemical ionization mode; therefore, it is further used for analysis of torasemide and its impurities. Both methods meet all validation criteria. The calibration curves show high linearity with the coefficients of correlation (r) greater than 0.9982. The obtained recovery values (95.78-104.92%) and relative standard deviation values (0.12-5.56%) indicate good accuracy and precision. Lower limit of detection (LOD) and limit of quantitation (LOQ) values are obtained with the LC-MS method, indicating higher sensitivity of the proposed method.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.