Gratings are essential components in different high performance optical set-ups such as spectrometers in space missions or ultrashort-pulse laser compression arrangements. Often such kinds of applications require gratings operating close to the technological accessible limits of today's fabrication technology. Typical critical parameters are the diffraction efficiency and its polarization dependency, the wave-front error introduced by the grating, and the stray-light performance. Additionally, space applications have specific environmental requirements and laser application typically demand a high damage threshold. All these properties need to be controlled precisely on rather large grating areas. Grating sizes of 200 mm or even above are not unusual anymore. The paper provides a review on how such high performance gratings can be realized by electron-beam lithography and accompanying technologies. The approaches are demonstrated by different examples. The first example is the design and fabrication of the grating for the Radial-Velocity-Spectrometer of the GAIA-mission of the ESA. The second grating is a reflective pulse compression element with no wavelength resonances due to an optimized design. The last example shows a three level blazed grating in resonance domain with a diffraction efficiency of approximately 86 %

Nonlinear Energy Sinks (NESs) have recently received increasing attention from researchers because of their capability to passively absorb a significant amount of energy over a wide range of frequencies. In most studies, the dynamic response of the main structure coupled with one or more NESs is analysed for impulsive loading. In this paper, the performance of the NES attached to a Single Degree of Freedom (SDOF) system, under random Gaussian white noise base excitations, is investigated through several numerical simulations. In order to determine the optimal configuration for the device, four different objective functions are considered. Sensitivity analyses with respect to the intensity of the random loads, the mass ratio and the main parameters of the primary structure are presented. The authors propose an approximate design approach based on the use of the Statistical Linearization Technique, and an accurate empirical formulation linking the NES optimal parameters to the characteristic of the main structure and the random excitation. Numerical results are validated by Monte Carlo simulations. Finally, a numerical application for a 2-DOFs system equipped with a NES has been presented in order to investigate the applicability of the proposed empirical approach for Multi Degrees of Freedom structures.

A resonance domain blazed grating, composed of an effective medium structure and a subsequent mode conversion layer, is designed, fabricated, and characterized. Due to the demanding high aspect ratio geometries, a technological approach for multilevel structures, assisted by atomic layer deposition technology, has been developed. The measured efficiency of about 90% exhibits the largest value yet reported for a multi-level fused silica transmission grating in the resonance domain, operating at non Littrow mounting, close to normal incidence

Fabrication of ultra-high aspect ratio exchangeable and customizable tips for atomic force microscopy (AFM) using lateral focused ion beam (FIB) milling is presented. While on-axis FIB milling does allow high aspect ratio (HAR) AFM tips to be defined, lateral milling gives far better flexibility in terms of defining the shape and size of the tip. Due to beam-induced deformation, it has so far not been possible to define HAR structures using lateral FIB milling. In this work we obtain aspect ratios of up to 45, with tip diameters down to 9 nm, by a deformation-suppressing writing strategy. Several FIB milling strategies for obtaining sharper tips are discussed. Finally, assembly of the HAR tips on a custom-designed probe as well as the first AFM scanning is shown.