No abstract

Environmentally friendly natural deep eutectic solvents (NADES) have been shown to efficiently extract a wide range of phenolic compounds from virgin olive oil (VOO). The objective of this work was to optimize the yield of olive oil phenols extracted by NADES based on choline chloride/xylitol (Xyl/ChCl). Different extraction and recovery conditions were investigated, including the effect of different extraction operating parameters (temperature, time, VOO:NADES ratio) and subsequent recovery conditions (XAD resin height, wash-water and eluent volume and pH). The highest concentration of phenols (555.36 mg/kg VOO) was obtained from extraction at 40º C for 1 h, with a 1:1 ratio, using an adsorption resin XAD-16 with bed height of 10 cm, 250 mL acidified wash-water and 300 mL EtOH 100% as eluent. No statistically significant loss of the sum of phenolic compounds was observed when compared with the concentration values obtained by direct analysis in HPLC without the elimination of NADES. Additionally, a sequential desorption with different concentration of ethanol was used to determine the effect of the solvent concentration on polyphenol yield. Polar compounds, such as hydroxytyrosol and tyrosol, were recovered at 81.7 % and 83.6 %, respectively; however, 100% ethanol was required for the complete elution of oleacein (3,4-DHPEA-EDA) and oleocanthal (p-HPEA-EDA). In this paper we present an effective process for the extraction of polyphenols from VOO by NADES for direct analysis in HPLC and for the recovery and concentration of polyphenols by removing the solvent (NADES) with no losses of yield and solvent recycling.

The production of ‘Premium’ olive oil depends in large part on the quality of the fruit. Small producers see themselves confronted with vast investments and logistic snags when they intend to optimize the harvesting. Today, manual harvesting devices promise less damaged fruit when compared to the traditional methods with nets while the use of a cooling room on the farm is suggested as a solution when the harvesting needs to be stretched out over several days. The use of a manual inverted umbrella during the harvest, together with a storage of up to 14 days at 5 °C, was studied for three cultivars (‘Arbequina’, ‘Picual’, and ‘Verdial’). Ten parameters of the produced oil were examined in two consecutive years together with an extended sensory analysis in the first year. The results underline the importance of the used harvesting and conservation method on the quality of the extracted oil, although the effect size of each factor varied in time and according to the cultivar. The results indicate that small producers with financial and logistic restrictions can obtain a high-quality product following the actions shown in this work, being able to compete in terms of quality in the market, either by combining both methods or by choosing the one that guarantees the best results given the cultivar and the specific storage time they need to consider.

No abstract

Cold storage of olive fruit has been the subject of study for over more than 50 years. From the 1990s on, an increasing amount of knowledge is build-up about the impact of the conservation on the physiological response of the fruit as well as on the quality of the extracted oil therefrom. This review offers a comprehensive synopsis of this research, discusses the most important influential factors and summarizes the results on the influence of the studied parameters on both the fruit and the oil. Currently, changing climatic conditions, new harvesting techniques and a more demanding consumer market are triggering the need to broaden this strict focus on conservation. A more dynamic view on the effects of temperature from the moment the fruit is harvested up to the oil extraction process, reveals the necessity to manage this crucial influential factor more diversely. An overview of how this management can take form is structured through a focus on the different phases of the postharvest processing and the widely different harvesting scales. Future prospects of research are presented based on the actual state of the art of cold storage research as well as on the necessities that come forward from a broader fruit temperature management perspective.

Bringing the olive harvest period forward leads to storing fruit in field temperatures that risk jeopardizing its quality. Knowledge about the bio-thermal characteristics of olives is crucial when considering their cooling, although published research on the subject is limited. In this work, the cooling rate of the fruit of six olive cultivars has been empirically determined by measuring the evolution of their low temperature under controlled conditions by thermal imaging. Based on these data, the cooling time needed to cool the fruit to 22 °C was estimated, considering the biometric characteristics of the individual fruit, a field temperature from 26 to 42 °C, and a room cooling temperature from −8 to −20 °C. The results showed differences among the cultivars and the need to further investigate the specific heat requirements for small varieties and the impact of the conduction factor on the heavier ones. The simulation suggests that between 2 min (for the light Arbequina and Koroneiki cultivars) and 5 min (for the heavier Verdial and Gordal cultivars) suffice to cool the fruit to the desired temperature with a room temperature of −16 °C. These results show the feasibility of developing technological solutions for cooling olives before their industrial processing with industrial applications such as cooling tunnels on individual fruit.

The use of three inorganic materials as potential immobilizers of metals in soils has been studied by monitoring metal availability by EDTA extraction, the Simple Bioaccessibility Extraction Test (SBET) and extraction with a mixture of organic acids (OA). The SBET test was the most suitable for risk assessment in soils of recreational areas. The materials were a 4A-type zeolite, tri-calcium phosphate and 'slovakite', a synthetic sorbent developed for remediation of metal-polluted soils. Adsorption/desorption experiments of metals by the isolated materials showed that all materials caused a strong retention of metals from solutions, with negligible release by dilution. When added to soils of three parks, zeolite and, to a much lesser extent, slovakite caused some increase in soil pH. Despite this increase of pH, zeolite is often the least effective amendment for decreasing metal availability estimated by any method, and even sometimes seems to cause some increase, as well as an increase of soil electrical conductivity. In contrast, slovakite causes a decrease of available metals as estimated by EDTA and SBET, but by SBET the effect seems to be steadily reduced after the first samplings, so that after 300 days the metals extracted by this method are very similar to the data for the blanks. Despite the differences in pseudo-total metal contents, few differences are noticeable among parks. In general, these amendments are scarcely efficient in the case of neutral urban soils like those studied here. Other techniques are needed for controlling and, eventually, decreasing metal pollution hazard in soils of recreational areas.

No abstract