Plastic has made our lives comfortable as a result of its widespread use in today’s world due to its low cost, longevity, adaptability, light weight and hardness; however, at the same time, it has made our lives miserable due to its non-biodegradable nature, which has resulted in environmental pollution. Therefore, the focus of this research work was on an environmentally friendly process. This research work investigated the decomposition of polypropylene waste using florisil as the catalyst in a salt bath over a temperature range of 350–430 °C. A maximum oil yield of 57.41% was recovered at 410 °C and a 40 min reaction time. The oil collected from the decomposition of polypropylene waste was examined using gas chromatography-mass spectrometry (GC-MS). The kinetic parameters of the reaction process were calculated from thermogravimetric data at temperature program rates of 3, 12, 20 and 30 °C·min−1 using the Ozawa–Flynn–Wall (OFW) and Kissinger–Akahira–Sunnose (KAS) equations. The activation energy (Ea) and pre-exponential factor (A) for the thermo-catalytic degradation of polypropylene waste were observed in the range of 102.74–173.08 kJ·mol−1 and 7.1 × 108–9.3 × 1011 min−1 for the OFW method and 99.77–166.28 kJ·mol−1 and 1.1 × 108–5.3 × 1011 min−1 for the KAS method at a percent conversion (α) of 0.1 to 0.9, respectively. Moreover, the fuel properties of the oil were assessed and matched with the ASTM values of diesel, gasoline and kerosene oil. The oil was found to have a close resemblance to the commercial fuel. Therefore, it was concluded that utilizing florisil as the catalyst for the decomposition of waste polypropylene not only lowered the activation energy of the pyrolysis reaction but also upgraded the quantity and quality of the oil.
This study presents the synthesis of activated orange peel, derived from bio-waste (orange peel) and its doping with selenium nano-particles to enhance the adsorption capacity. The synthesized nanocomposite orange peel/Selenium (OP/Se) was applied as adsorbents for the removal of Lead (Pb) and Chromium (Cr) from synthetic waste water as an economical water cleaning technology. Orange peel/Selenium nanocomposite was characterized by X-Ray diffraction (XRD), Fourier transform infrared spectroscopy (FT-IR) and Scanning electron microscopy (SEM). Scanning electron microscopy results showed the porous structure of OP/Se nanocomposite and distinct peaks observed in XRD and FTIR spectra depicted the successful synthesis of nanocomposite. Batch experiments were conducted to figure out the effect of different parameters on adsorption of Pb and Cr by using Atomic Absorption Spectroscopy. The maximum adsorption capacity of 99.9% was achieved for both lead and chromium at acidic pH. While at temperature of 60°C the maximum adsorption of 98.3 and 95.9% was found for Pb and Cr respectively. Furthermore the experimental data was examined with Pseudo-first order, first-order and Pseudo-second order kinetic model, as well as Morris Intraparticle diffusion model where the pseudo second order was best fitted which indicated the chemisorption mechanism in adsorption process. The adsorption process followed the Langmuir isotherm model verified that OP/Se nanocomposite was found to be favorable for the process of adsorption. The adsorption thermodynamics indicate that adsorption of heavy metals ions is spontaneous (ΔG° < 0) and the adsorption increases with increase in temperature which means that reaction was endothermic in nature. This study revealed that the synthesized bio-activated nanocomposite was an efficient adsorbent material for the removal of heavy metals from waste water.
Nanoscience has developed various greener approaches as an alternate method for the synthesis of nanoparticles and nanocomposites. The present study discusses the efficacy of berries extract for the synthesis of ZnO nanocomposites. Characterization of synthesized nanocomposite were done by SEM, UV/VIS spectrophotometry, Fourier transform infrared (FTIR) spectroscopy, and XRD techniques. The crystalline nature of the synthesized nanoparticles was verified by XRD pattern in the range of 10-80 nm. The UV absorption peak of Elaeagnus umbellata (ZnO-EU) nanocomposite at 340 nm, Rubus idaeus (ZnO-Ri) nanocomposite at 360 nm, and Rubus fruticosus (ZnO-Rf) nanocomposite at 360 nm was observed. The nanocomposites were analyzed for their antimicrobial activity and found to be effective against three phytopathogens. The antimicrobial activity of ZnO nanocomposites showed good results against Escherichia coli (341), Staphylococcus aureus (345B), and Pseudomonas aeruginosa (5994 NLF). This study presents a simple and inexpensive approach for synthesizing zinc oxide nanocomposites with effective antibacterial activity.
The theme of the review article is to highlight the link between Rheumatoid Arthritis and atherosclerosis with emphasis on inflammation as the root cause for both the diseases. The article therefore stresses on the aggressive treatment of inflammation in RA patients and get the patients in remission to slower down the progress of atherosclerosis which is the main cause of mortality in RA patients due to cardiovascular disease (CVD) events.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.
hi@scite.ai
10624 S. Eastern Ave., Ste. A-614
Henderson, NV 89052, USA
Copyright © 2024 scite LLC. All rights reserved.
Made with 💙 for researchers
Part of the Research Solutions Family.