BSTRACT: The aim of this study was to expand the International Water Association Activated Sludge Model No. 2d (ASM2d) to account for a newly defined readiiy biodegradable substrate that can be consumed by polyphosphate-accumulating organisms (PAOs) under anoxic and aerobic conditions, but not under anaerobic conditions. The model change was to add a new substrate component and process terms for its use by PAOs and other heterotrophic bacteria under anoxic and aerobic conditions. The Gdansk (Poland) wastewater treatment plant (WWTP), which has a modified University of Cape Town (MUCT) process for nutrient removal, provided field data and mixed liquor for batch tests for model evaluation. The original ASM2d was first calibrated under dynamic conditions with the results of batch tests with settled wastewater and mixed liquor, in which nitrate-uptake rates, phosphorus-release rates, and anoxic phosphorus uptake rates were followed. Model validation was conducted with data from a 96-hour measurement campaign in the full-scale WWTP. The results of similar batch tests with ethanol and fusel oil as the external carbon sources were used to adjust kinetic and stoichiometric coefficients in the expanded ASM2d. Both models were compared based on their predictions of the effect of adding supplemental carbon to the anoxic zone of an MUCT process. In comparison with the ASM2d, the new model better predicted the anoxic behaviors of carbonaceous oxygen demand, nitrate-nitrogen (NOi-N), and phosphorous (PO4-P) in batch experiments with ethanol and fusel oil. However, when simulating ethanol addition to the anoxic zone of a full-scale biological nutrient removal facility, both models predicted similar effluent NO3-N concentrations (6.6 to 6.9 g N/m^). For the particular application, effective enhanced biological phosphorus removal was predicted by both models with external carbon addition but, for the new model, the effluent PO4-P concentration was approximately onehalf of that found from ASM2d. On a PO4-P removal percentage basis, the difference was small, that is, 94.1 vs 97.1%, respectively, for the ASM2d and expanded ASM2d. Water Environ. Res., 84, 646 (2012).

No abstract

Food industry effluents are considered a potential alternative for methanol when seeking external carbon sources to enhance denitrification in municipal wastewater treatment plants (WWTPs). The aim of this study was to determine the immediate effects of dosing different carbon sources on the denitrification capability of process biomass from the Wschod WWTP in Gdansk (northern Poland). Five carbon sources, including settled wastewater, methanol, and three industrial effluents (distillery, brewery, and fish-pickling process) were tested in two kinds of batch experiments. The acclimation period of biomass to methanol also was investigated in bench-scale systems. During the conventional batch experiments, with the industrial effluents, the observed nitrate utilization rates (NURs) ranged from 2.4 to 6.0 g N/(kg VSS?h), which were only slightly lower than the rates associated with the use of the readily biodegradable fraction in the municipal (settled) wastewater [4.6 to 7.8 g N/(kg VSS?h)]. The conventional NURs observed with methanol and non-acclimated process biomass were low [i.e., 0.4 to 1.5 g N/(kg VSS?h)], and a minimum 2-week acclimation period of biomass to methanol in the bench-scale systems was needed to reach the level of 4.0 g N/(kg VSS?h). In other experiments, dosing the distillery and fish-pickling effluents at the beginning of the anoxic phase (preceded by the anaerobic phase) resulted in considerably higher (over 20%) NURs compared with the same experiments with the other carbon sources. Water Environ. Res., 81, 896 (2009).

The most challenging issue for existing large WWTPs (>100,000 PE) in Poland will be achievement of the new effluent standards for total nitrogen. Consequently, reliable and accurate information concerning the dimensioning of anoxic compartments is necessary. This study focused on validating to what extent the denitrification rates determined from batch tests were comparable with the rates calculated based on a mass balance over a full-scale activated sludge reactor. The experiments were conducted at two large WWTPs in northern Poland: "Wschod" in Gdansk and "Debogorze" in Gdynia. Two types of batch tests were used to determine the denitrification capability of activated sludge. Lower nitrate utilization rates observed during the full-scale experiments could potentially result from the local disturbances such as nitrate limitation ("Wschod" WWTP) or oxygen penetration to the anoxic zone ("Debogorze" WWTP). These factors should be taken into consideration during the design phase of the anoxic compartments.

This paper presents effects of dispersion on predicting longitudinal ammonia concentration profiles in activated sludge bioreactor located at "Wschod" WWTP in Gdansk. The aim of this study was to use the one-dimensional advection-dispersion Equation (ADE) to simulate the flow conditions (based on the inert tracer concentrations in selected points) and longitudinal profile of reactive pollutant (based on the ammonia concentration profiles in selected points). The simulation results were compared with the predictions obtained using a traditional "tanks-in-series" (TIS) approach, commonly used in designing biological reactors. The use of dispersion coefficient calculated from an empirical formula resulted in substantial differences in the tracer concentration distributions in two sampling points in the bioreactor. Simulations using the one-dimensional ADE and TIS model, with the nitrification rate incorporated as the source term, revealed that the hydraulic model plays a minor role compared to the biochemical transformations in predicting the longitudinal ammonia concentration profiles.

Mathematical modelling and computer simulation have became a useful tool in evaluating the operation of wastewater treatment plants (WWTPs) in terms of nutrient removal capability. In this study, steady-state simulation results for two large biological nutrient removal WWTPs are presented. The plants are located in two neighbouring cities Gdansk and Gdynia in northern Poland. Simulations were performed using a pre-compiled model and layouts (MUCT and Johannesburg processes) implemented in the GPS-X simulation package. The monthly average values of conventional parameters, such as COD, Total Suspended Solids, total N, N-NH4+, P-PO4- were used as input data. The measured effluent concentrations of COD, N-NH4+, N-NO3- and P-PO4- as well as reactor MLSS were compared with model predictions. During calibration, performed from the process engineering perspective, default values of only five model parameters were changed. The opportunities for further applications of such models in municipal WWTPs are discussed.

Carbon source alternatives for denitrification belong to the highest research area priorities as they allow to optimize N removal within the existing capacities. In particular, some food industry effluents appear to be good candidates for such alternatives due to their high C/N ratios and high content of readily biodegradable organic fraction. The aim of this study was to determine the immediate effects of dosing different types of industrial wastewater on the denitrification capability of process biomass originating from the "Wschod" WWTP in Gdansk (northern Poland). Three types of industrial wastewater (effluents from a distillery, brewery and fish-pickling factory) were tested in two kinds of batch experiments. The results of this study revealed that the investigated industrial wastewater can be a potential external carbon source to improve denitrification efficiency. The observed single nitrate utilization rates (NURs) were ranging from 2.4 to 6.0 g N/(kg VSS.h) and were comparable to the rates associated with the utilization of readily biodegradable COD in the settled wastewater. When the NURs were measured during anoxic P uptake, the P uptake rates did not appear to be adversely affected by the addition of any carbon source.

The capabilities of denitrifying Polyphosphate Accumulating Organisms (DPAOs) in two large-scale plants in northern Poland performing enhanced biological phosphorus removal (EBPR) were evaluated in this study. A series of batch tests with the process biomass aimed at the measurements of phosphate release (with artificial substrate and real wastewater) and subsequent phosphate uptake under anoxic/aerobic conditions. The process kinetics were predicted using ASM2d implemented in the GPS-X ver. 4.0.2 simulation package. The results from one experimental series (summer) were used for the model calibration, whereas the results from another series (spring) were used for the model validation. The model parameters were also accurately confirmed by predictions of the accompanying field measurements in the full-scale bioreactors. The experimental and simulation results revealed that a relatively small fraction of PAO could denitrify (eta(NO3,PAO) = 0.32). The denitrification rates associated with the anoxic storage of PP and the anoxic growth of PAO only constituted 16.0-21.0% of the denitrification rates associated with the anoxic activity of "ordinary" heterotrophs.